Full Refrigerator Configuration; Operating Your Beer Dispenser - Vinotemp VT - PONYKEG Owner's Manual

FULL REFRIGERATOR CONFIGURATION

To convert appliance into "All Refrigerator" configuration, please follow below:
1. Turn th e control knob to the "OFF" position.
2 . Close the main valve on the CO
3. Close the secondary shut-off valve on the regulator pipe.
4. Close the connection between the beer keg a
5. Drain any remaining beer from the lines.
6. Disconnect the beer line and CO
7. Remove the beer keg and bottom metal plate.
8. Remove the keg coupler.
9. Disconnect the air line from the CO
10. Remove the CO air line from cabinet plug
2
11. Replace the air line rear ca
12. Remove the beer tower. Also pull the beer line
13. Replace the top cabinet plug.
14. Remove the guard rail and cover the g
15. Install the two wire shelves to the designated positions.
16. Adjust temperature as desired
OPERATING
Setting The Temperature
To start, turn the temperature control knob to the maximum setting (6). Allow
r un for a minimum of 3 hours at the maximum setting to cool down
unit. Temperature range of th
(2.2ºC to 7.2ºC). Thereafter, adjust the thermostat to desired
temperature.
Optimum temperature for serving draught beer is 34°F –
(1.1ºC – 3.3º C) and that is a key factor to consider in storing and
d ispensing draught beer. Note: Suggested temperature control knob
position is between "4" and "5".
To turn off the beer dispenser, turn the control knob to the "OFF" posit
N OTE: Keep an accurate thermometer handy and adjust temperature control setting as
necessary or according to your needs.
Automatic Defrosting
T here is no need to defrost the beer dispenser. Defrost water collects and passes through
e drain outlet in the rear wall into a tray located above the compressor, where it
th
evaporates.
NOTE:
IF THE UN IT IS UNPLUGGED, LOST POWER, OR TURNED OFF, YOU MUST WAIT 3 TO 5
MINUTES BEFORE RESTARTING THE UNIT. IF YOU ATTEMPT TO RESTART BEFORE
THIS TIME DELAY, THE BEER DISPENSER WILL NOT START.
TURNING THE TEMPERATURE CONTROL TO "OFF" POSITION STOPS THE COOLING
CYCLE BUT DOES NOT SHUT OFF THE POWER TO THE UNIT.
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
cylinder.
2
nd the keg coupler.
air line from the keg cou
2
cylinder.
2
binet plug.
thru the top of the cabinet.
uard rail installation holes by the provided plugs.
.
YOUR BEER DISPENSER
e thermostat goes from 36°F to 45°F
i n f o @ v i n o t e m p . c o m
pler.
the unit to
38°F
ion.
11