Table of Contents
Advertisement
4.3.2.1 Ethernet Over ATM (RFC 1483 Bridged) without NAT
This WAN type disable the NAT, this device becomes a pure bridge between your LAN and WAN, all
the clients in your LAN must have legal IPs. If you enable the NAT feature, you have to set the
following WAN IP settings.
WAN IP Address, WAN Subnet Mask, WAN Gateway, and Primary/Secondary
DNS
These settings are also specified by your ISP.
VPI/VCI Numbers:
The channel settings provided by your ISP.
Schedule Type:
The setting of the ADSL traffic schedule type. This device supports UBR (Un-specified bit rate) and
CBR (Constant bit rate). Once you finished the required configuration, you must click on the "Save"
button to save the configuration into Flash memory, and the reboot this device.
21
Advertisement
Table of Contents
