Installing The Vacuum Hose; On/Off Switch - Performax 241-0950 Owner's Manual

INSTALLING THE EDGE GUIDE – cont'd
NOTE: The edge guide can be installed on
either the left or right hand side of the tool.
3. Slide the edge guide foot (6) toward the
tool until the desired width of cut is
indicated on the scale where it meets the
right hand edge of the trapezoidal window
(7).
4. Tighten the edge guide locking screw.
NOTES:
a) Do not over tighten the edge guide
locking screws or you will damage the
edge guide.
b) The edge guide scale is only an
approximate measurement. Always check
the width of cut on a scrap workpiece.

INSTALLING THE VACUUM HOSE

The vacuum adaptor and hose can be used to
attach a workshop vacuum hose to the tool. This
will prevent most cutting dust from escaping into
the work area.
1. Push the small vacuum connector (1) on
the end of the vacuum hose (2) over the
vacuum port (3) on the right hand side of
the tool (Fig. 5).
2. Twist and push the vacuum connector to
lock it into position.
3. Connect a workshop vacuum hose to the
opposite end of the vacuum hose.
ASSEMBLY AND OPERATING
Fig. 4
!
WARNING
For safety reasons, the operator must
read the sections of this Owner's Manual
entitled "GENERAL SAFETY
WARNINGS", "POWER TOOL SAFETY",
"SPECIFIC SAFETY RULES",
"EXTENSION CORD SAFETY" and
"SYMBOLS" before using this multi-cut
saw.
Verify the following every time the multi-
cut saw is used:
1. Correct blade is installed for the
material being cut.
2. Blade is in good condition and is
properly installed.
3. Blade guard is in place and is in
good working order.
4. Workpiece is properly secured.
5. Safety glasses, dust mask and
hearing protection are being worn.
Failure to observe these safety rules will
significantly increase the risk of injury.

ON/OFF SWITCH

This tool has dual purpose ON/OFF switch that
is designed to prevent accidental starting of the
tool. It also automatically turns the tool OFF
then the switch is not held in the ON position.
16
Fig. 5