Troubleshooting; General Troubleshooting - Qualcast MEB1334M Instruction Manual

Troubleshooting

General Troubleshooting

The following table provides solutions to common problems encountered with the mower.
Fault
Mower does not start
Motor stops
Untidy finish, motor labours
Blade fails to turn
Strange noises, rattling or
vibrations
Possible Cause
No power at mains socket
Defective on/off switch
Worn carbon brushes
Defective motor
Grass too long
Blade is blocked
Cut height too low
Blade blunt
Blade area blocked
Blade assembled incorrectly
Blade blocked by grass
Blade screw loose
Blade screw loose
Blade damaged
Customer Helpline 08456 400 800
Solution
Check the fuse, switch,
socket, cable, wire and have
any repairs carried out by a
qualified electrician
Repair by a qualified technician
required
Set at a higher cut setting.
Lift the front wheels slightly by
pressing down on the handle
bar.
Disconnect from mains and
remove blockage
Set a higher cut height
Sharpen or replace the blade
Remove blockage
Install the blade correctly
Remove blockage
Tighten the blade screw
Tighten the blade screw
Replace the blade
21