Step 2 - Top Handle Assembly - Qualcast MEB1334M Instruction Manual

Assembly

Step 2 - Top Handle Assembly

3c
5
10
• The top, curved handle section
bolt, washer and quick release lever
necessary by inserting the bolt into the required holes on the handle (2c).
• Hold the curved handle in the desired operating position (fig 1). Fix the handle in this position by
tightening (clockwise) the quick release levers then fold them against the handle. These levers
should be folded in towards the handle using moderate force to lock them in position. When
locked there should be no play between the top and bottom handle assemblies.
To tighten, unfold these lever, turn them clockwise, then fold them back (2d).
To loosen, unfold these levers, turn anticlockwise, then fold them back in (2d).
Several adjustments may be needed to find the correct setting. Do not force.
6
5 is assembled to the bottom handle supports
on either side. Adjust the height to suite the operator as
6
Customer Helpline 08456 400 800
3d
6
using a
10
11