Assembly; Step 1 - Bottom Handle Support Assembly - Qualcast MEB1334M Instruction Manual

Assembly

Step 1 - Bottom Handle Support Assembly

2a
• The bottom handle support
plastic quick release lever. If the handle is not pre-fitted in the box push the bolt (from the inside
towards the outside) through the deck, handle, then washer, and fasten into the metal retainer in
the plastic lever, in that order.
• Ensure all the plastic quick release levers are unfolded. Hold the bottom handle support at the
desired angle (2a) for operation. Fix the handle in this position by tightening the quick release levers
(clockwise) and then locking them into position by folding the levers snug against the handle.
These levers should be folded in towards the bar using moderate force to lock them in position. If
they feel too tight when you fold them, turn them anti-clockwise to loosen them and then attempt
to fold them again. Do not use excessive force.
• To tighten turn clockwise, or to loosen turn anticlockwise, before folding them.
10
10
is attached to the deck on either side using a bolt, washer and
10
Customer Helpline 08456 400 800
2b