Operation - Makita XSH03 Instruction Manual

1
2
015109
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
COUNTERCLOCKWISE SECURELY.
When changing blade, make sure to also clean the upper and
lower blade guards of accumulated sawdust as discussed in
the Maintenance section. Such efforts do not replace the need
to check lower guard operation before each use.
1 2
3
011231
Mount the inner flange with its recessed side facing
outward onto the mounting shaft and then place saw
blade, outer flange and hex bolt.
BE SURE TO TIGHTEN
COUNTERCLOCKWISE SECURELY.
Hex wrench storage
1
015110
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1. Inner flange
2. Saw blade
3. Outer flange
4. Hex bolt
3
4
1. Mounting shaft
5
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
4
THE HEX
1. Hex wrench
Connecting a vacuum cleaner
(Optional accessory)
015195
2
015112
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner to your tool.
Replace the lever on the lower guard to the one supplied
with the dust nozzle. Install the dust nozzle on the tool using
the screw. Then connect a hose of the vacuum cleaner to
the dust nozzle as shown in the figure.

OPERATION

BOLT
CAUTION:
Be sure to move the tool forward in a straight line
•
gently. Forcing or twisting the tool will result in
overheating the motor and dangerous kickback,
possibly causing severe injury.
Always use a front grip and rear handle and firmly
•
hold the tool by both front grip and rear handle
during operations.
015117
Hold the tool firmly. The tool is provided with both a front
grip and rear handle. Use both to best grasp the tool. If both
hands are holding saw, they cannot be cut by the blade. Set
the base on the workpiece to be cut without the blade
making any contact. Then turn the tool on and wait until the
blade attains full speed. Now simply move the tool forward
10
1. Dust nozzle
2. Screw
3. Lever
1
2
3
1. Vacuum cleaner
2. Hose
1