Table of Contents
Advertisement
• VIEW ANGLE SETUP
FLIP
OFF: The dome camera moves until 90° vertically.
AUTO: When the camera reaches the floor directly above the moving object, it will stop. At
that time, release the Joystick instantly and pull it down again to run the auto-flip function.
When you use the panning range, it is recommended to use the flip mode to AUTO.
90°, 100°, 110°, 120°: Allows the image to flip digitally when the camera moves over the
setting angle vertically.
TILT ANGLE LIMIT
This option is designed to limit the view angle as there is some obstruction in zooming out on
specific areas of the tilt angle.
NOTE: Focus issues may occur if the tilt angle limit is set below 10 degree.
PANNING RANGE
When the dome camera is installed near a wall, panning range can be limited by user.
1. Place the dome camera under 90 degree vertically.
2. Set "RIGHT LIMIT" by pushing the Joystick to the right.
3. Set "LEFT LIMIT" by pushing the Joystick to the left.
4. Set "ENABLE" to ON to use.
To exchange the right and the left limit, set "SWAP" to ON.
To apply limits on the auto pan (endless panning), set "AUTO PAN" to ON.
NOTE: When the flip mode is 90°, 100°, 110° or 120° and you moves over 90° vertically,
the panning range operates in opposite side.
VIEW ANGLE SETUP
PANNING RANGE
FLIP
TILT ANGLE LIMIT
SAVE AND EXIT(ESC TO CANCEL)
OFF, AUTO, 90°, 100°, 110°, 120°
-10° ~ 10°
PANNING RANGE SETUP
RIGHT LIMIT
LEFT LIMIT
ENABLE
SWAP
AUTO PAN
SAVE AND EXIT(ESC TO CANCEL)
24
: 90°
: 00°
(CTRL KEY)
: 000.0
: 000.0
: OFF
: OFF
: ON
Advertisement
Table of Contents
