Table of Contents
Advertisement
3.7 Tour
(Shortcut: TOUR)
There are 8 programmable Tours. Each Tour consists of up to 42 Preset positions, Patterns, Scans
or other Tours (second-level). Using second-level Tours, it can be expanded to over
300 functions in a single Tour.
Follow the steps below to program the Tours:
1. Press the MENU key to display the main menu on the monitor. Scroll to Tour and push the
Joystick to the right to enter the Tour menu. Or just press the TOUR key on the keyboard.
2. Select "NUMBER" and set the desired number by pushing the Joystick to the left or right.
3. Choose a blank position to be programmed by pushing the Joystick up, down, right, or left.
4. To add a stored Preset, twist the Joystick then the stored Preset number displays.
5. To place functions other than Preset, press the TOUR, PTRN or SCAN keys for Tour, Pattern
or Auto Scan respectively.
6. You can also overwrite the programmed number and remove a stored number from the Tour,
press the HOME key on the stored number, a blank position mark (---) will be displayed.
7. Repeat step 2 through 6 for each desired position. Each title will be displayed on top of the line.
8. To edit the "TITLE", follow the procedure of the Auto Scan above to edit titles.
TOUR SETUP
NUMBER
TITLE
SCAN TYPE
SPEED
TOUR FUNC
SAVE AND EXIT(ESC TO CANCEL)
TOUR FUNC SETUP
DWELL
003 A04 --- --- ---
--- --- --- --- ---
--- --- P01 --- ---
--- T02 --- --- ---
--- --- --- --- ---
--- --- --- --- ---
--- --- --- --- ---
--- --- --- --- ---
EXIT(ESC TO EXIT)
---
Blank position
SCAN TYPE
NORMAL, VECTOR
DWELL
03 ~ 99 seconds
003
Preset (1 ~ 240)
A04
Auto Scan (1 ~ 8, 10 ~ 17)
P01
Pattern (1 ~ 8)
T02
Tour (1 ~ 8)
: 01
: T01
: NORMAL
: -- STEP
(CTRL KEY)
: -- SEC
14
Advertisement
Table of Contents
