Table of Contents
Advertisement
3.13 Dome Setup
• HOME FUNCTION SETUP
FUNCTION
NUMBER
WAITING TIME
ENABLE
The Home Function can be set so that the camera automatically goes to Tour, Pattern,
Auto Scan or Preset after the keyboard controller has been idle for a specified amount of time.
For example, if the controller is idle for 120 seconds, the camera goes to Preset 1.
Follow these steps to program the Home position:
1. Select "FUNCTION" by pushing the Joystick to the left or right to scroll through the None,
Tour, Pattern, Auto Scan or Preset functions.
2. Select "NUMBER" and push the Joystick to the left or right. The recorded function number
will scroll.
3. Select "WAITING TIME" and push the Joystick to the left or right to select from 10 to 240
seconds.
4. Select "ENABLE" and turn to ON or OFF by pushing the Joystick to the left or right.
CONFIGURATION MENU
HOME FUNCTION SETUP
VIEW ANGLE SETUP
ORIGIN OFFSET
FACTORY DEFAULT
DOME RESET
OSD DISPLAY
SYSTEM SETUP
FUNCTION RUN
SYSTEM INFORMATION
EXIT(ESC TO EXIT)
HOME FUNCTION SETUP
FUNCTION
NUMBER
WAITING TIME
ENABLE
SAVE AND EXIT(ESC TO CANCEL)
NONE, TOUR, PATTERN, AUTO SCAN, PRESET
---
10 ~ 240 seconds
ON, OFF
: NONE
: ---
: 120 SEC
: OFF
23
Advertisement
Table of Contents
