Configuring [Smart Transfer]; Transferring Automatically - Panasonic Lumix DMC-ZS45 Owner's Manual

Configuring [Smart Transfer]

When using Smart Transfer for the first time, follow the steps below to set it up.
From the next time on, you can change the settings from [Set Destination] (P144).
1
Select [Wi-Fi Setup] in the [Wi-Fi] menu, and press [MENU/SET].
2
Press 3/4 to select [Smart Transfer], and press [MENU/SET].
3
Select the method for connecting to a wireless access point, and set.
• P146
Refer to
4
Set the transfer destination.
•
For details about the preparations before the transfer, refer to "When sending images to PC" on
P139.
1 Press 3/4 to select a PC you want to connect, and then press [MENU/SET].
2 Press 3/4 to select the folder you want to send, and then press [MENU/SET].
5
Press 3/4 to select [Auto Transfer], and press [MENU/SET].
6
Press 3/4 to select [ON], and press [MENU/SET].
•
Only the images you recorded when [Auto Transfer] is set to [ON] is transferred.

Transferring automatically

You can transfer images while charging the camera.
Preparation:
Configure [Smart Transfer] in advance.
1
Turn off the camera.
2
(When using a power outlet)
Connect the AC adaptor (supplied) and this camera with the USB connection cable
(supplied), and insert the AC adaptor (supplied) into the power outlet.
(When using a PC)
Connect this unit to a PC by using the USB connection cable (supplied).
•
Smart Transfer will start.
(When the remaining battery power is low, charging may be given the priority.)
•
Depending on the specifications of the PC, [Smart Transfer] may fail.
•
If there are images that are not transferred when [Auto Transfer] is set to [OFF], the message that
confirms whether to transfer these images is displayed. Select a desired option.
for details.
Wi-Fi
(P143)
- 143 -
(P41)