Connection Via Wlan - Casio IT-9000 Series Quick Start Manual

5.3 Connection via WLAN

To establish communication between IT-9000 with the WLAN module integrated (see Table 2.1 for
the applicable models) and PC via WLAN configuration, follow the steps, 1 to 6, below to set up a
WLAN configuration on IT-9000. After setting up the configuration, be sure to perform a site
survey prior to starting communication via WLAN.
1. Navigate to Start → Settings → Ctrol Panel → WLANConfig and then click IP tab.
Figure 5.20
Table 5.1
Enable DHCP or Configure IP
IP
MASK
GateWay
DNS1
DNS2
WINS1
WINS2
If any of the settings in Figure 5.20 is omitted, the process described in the following table will
automatically take place in the field.
Table 5.2
Parameter
Enable DHCP or
Configure IP
IP
MASK
GateWay
DNS1
DNS2
WINS1
WINS2
Parameter
Nothing is set (DHCP)
"Enable DHCP" is assumed.
Does not determine IP address.
Does not determine subnet mask.
Does not determine gateway.
Does not determine primary DNS address.
Does not determine secondary DNS address.
Does not determine primary WINS address.
Does not determine secondary WINS
address.
Determines "Enable" or "Disable" for DHCP.
Determines IP address.
Determines subnet mask.
Determines default gateway.
Determines primary DNS address.
Determines secondary DNS address.
Determines primary WINS address.
Determines secondary WINS address.
39
Description
"Configure IP" is set
"Configure IP" is set.
Entered address is set as is.
Entered address is set as is.
Entered address is set as is.
Entered address is set as is.
Entered address is set as is.
Entered address is set as is.
Entered address is set as is.