Casio IT-9000 Series Quick Start Manual page 27

4. Before using the cradle ports, remove the caps from the ports. When using a LAN, connect one
end of the LAN cable to the LAN port and the other end to the PC or hub. When using a USB
connection, connect one end of the USB cable (DT-380USB) to the USB port and the other end
to the PC.
5. Align the power/signal contacts on the underside of IT-9000 with the power/signal contacts on
the Ethernet Cradle and then set IT-9000 into the cradle so that mount holes in the back of
IT-9000 are aligned with the mount hooks on the cradle. Once IT-9000 is properly set in the
cradle, the power LED on the front of the Ethernet cradle lights green.
Status of Indicator 1 on IT-9000
Orange
Red
Green
Notes:
• Always remove IT-9000 from the Ethernet Cradle before changing the selector switch setting.
• Never short out the power/signal contacts of the cradle. This damages the cradle.
• Do not subject the IT-9000 and cradle to vibration or impact during communication. This results
in communication being interrupted.
• When mounting IT-9000, securely attach it to the mount hooks of the cradle and check that the
power LED on the front of the cradle lights green. Charging battery pack or communication will
not proceed if it is not mounted properly.
• The LAN and USB connections cannot be used concurrently.
• Always cap ports that are not being used. Using the Ethernet Cradle while the ports are
uncapped can cause damage.
: Charging
: Standby due to battery pack error or the surrounding temperature is out of range
(charging begins when the temperature is within the correct range.)
: Charging complete
27