Finisher Eject Set Jam - Lexmark w850 Service Manual

4024-XXX
Step Check
3 Check the drive motor (exit) for correct operation.
Check the above motor by opening the finisher front
door assembly and then closing it.
Does the motor (exit) rotate normally?
4 Check the drive motor (exit) connection.
Is the above motor connected properly?
5 Perform a teat print.
Does the error still occur?

285.00 Finisher eject set jam

Step Check
1 Check the media path.
Check the media eject shaft by turning it with your
fingers.
Is the media eject shaft assembly installed correctly,
meaning does it rotate smoothly?
2 Check the media eject clamp motor by opening the
finisher front door assembly, and then closing it.
Does the media eject clamp motor rotate normally?
3 Check the media eject motor connection.
Is the above motor connected properly?
4 Check the compiler media in actuator for correct
operation.
Is the actuator operating correctly?
2-42
Finisher Service Manual
Yes No
Go to step 5. Go to step 4.
Replace the drive Replace the
motor (exit). Go connection.
to "Drive motor
(exit) assembly
and belt (exit)
removal" on
page 4-113.
Replace the Problem solved.
finisher controller
card assembly.
Go to "Finisher
controller card
assembly
removal" on
page 4-118.
Yes No
Go to step 2. Clean or replace
the media eject
shaft assembly
and clean the
media path.
Go to step 4. Go to step 3.
Disconnect then Replace the
reconnect the connection.
connector P8304
on the finisher
controller card
assembly.
Perform a test
print, if the error
still occurs
replace the
media eject
motor assembly.
Go to step 5. Reinstall the
compiler media in
actuator. Go to
"Sensor
(compiler media
in) removal" on
page 4-73.