Punch Waste Box Full - Lexmark w850 Service Manual

Step Check
4 Perform a test print.
Does the error still occur?
5 Perform a test print.
Does the error still occur?

Punch waste box full

Step Check
1 Check the sensor (punch waste box full) for correct
installation.
Is the sensor installed properly?
2 Check the sensor (punch waste box full).
Perform the sensor (punch waste box full) test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Punch and Staple.
5. Select Punch waste box full.
Open the finisher front door.
Remove the punch waste box.
Insert a sheet of white media into the sensor (punch
waste box)
Does the display on the operator panel change every
time the sensing area of the sensor (punch waste box
full) is blocked?
3 Perform a test print.
Does the error still occur?
Yes No
Replace the Problem solved.
bridge interface
card assembly.
Go to "Bridge
unit interface
card assembly
removal" on
page 4-117.
Go to step 5.
Replace the Problem solved.
finisher controller
card assembly.
Go to "Finisher
controller card
assembly
removal" on
page 4-118.
Yes No
Go to step 2. Reinstall the
sensor (punch
waste box full).
Go to
(punch waste
box full)
removal" on
page
Go to step 4. Go to step 3.
Replace the Replace the
sensor (punch connection.
waste box full).
Go to "Sensor
(punch waste
box full)
removal" on
page 4-53.
Diagnostic information
4024-XXX
"Sensor
4-53.
2-93