Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Seagate ST3000LM016
Summary of Contents for Seagate ST3000LM016
- Page 1 Seagate® Laptop HDD SATA 2.5" Product Manual 100772113, Rev. D February 2016...
- Page 2 Actual data rates may vary depending on operating environment and other factors. The export or re-export of hardware or software containing encryption may be regulated by the U.S. Department of Commerce, Bureau of Industry and Security (for more information, visit www.bis.doc.gov), and controlled for import and use outside of the U.S. Seagate reserves the right to...
-
Page 3: Table Of Contents
4.7 Authenticated Firmware Download ....................22 Seagate Laptop HDD Product Manual, Rev. D... - Page 4 5.3.3 S.M.A.R.T. commands......................32 Seagate Laptop HDD Product Manual, Rev. D...
- Page 5 Mounting Dimensions (for 1-disk models) ............19 Seagate Laptop HDD Product Manual, Rev. D...
-
Page 6: Seagate® Technology Support Services
For information regarding online support and services, visit: http://www.seagate.com/contacts/ For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/seagate-recovery- services/recover/ For Seagate OEM, Distribution partner and reseller portals, visit: http://www.seagate.com/partners/ Seagate Laptop HDD Product Manual, Rev. D... -
Page 7: Introduction
Introduction This manual describes the functional, mechanical and interface specifications for the following Seagate® Laptop HDD model drives: Standard models SED Models ST3000LM016 ST4000LM016 ST3000LM012 ST4000LM012 ST3000LM017 ST4000LM017 ST3000LM013 ST4000LM013 ST3000LM018 ST4000LM018 ST3000LM014 ST4000LM014 Previous generations of Seagate Self-Encrypting Drive models were called Full Disk Encryption (FDE) models Note before a differentiation between drive-based encryption and other forms of encryption was necessary. -
Page 8: About The Serial Ata Interface
Register Block. All Serial ATA devices behave like Device 0 devices. For additional information about how Serial ATA emulates parallel ATA, refer to the Serial ATA International Organization: Serial ATA (Revision 2.6). The specification can be downloaded from www.serialata.org. Seagate Laptop HDD Product Manual, Rev. D... -
Page 9: Specifications
1.2 A Voltage tolerance (including noise) 5V ± 5% Operating temperature 0° to 60°C Nonoperating temperature (Ambient) –40° to 70°C 20°C per hour max (operating) Temperature gradient (max) 35°C per hour max (nonoperating) Seagate Laptop HDD Product Manual, Rev. D... - Page 10 600,000 at 25°C, 50% rel. humidity Supports Hotplug operation per the Serial ATA Revision 3.2 specification One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. Seagate Laptop HDD Product Manual, Rev. D...
-
Page 11: Formatted Capacity
Recording method Perpendicular 2900 Kb/in Recording density 486 Ktracks/in avg Track density 1026 Gb/in2 avg Areal density 5400 RPM Spindle speed 130 MB/s max Sustained data transfer rate 600 MB/s max I/O data-transfer rate Seagate Laptop HDD Product Manual, Rev. D... -
Page 12: Physical Characteristics
Seek time is defined as the time from the receipt of a read, write or seek command until the actuator has repositioned and settled on the desired track with the drive Note operating at nominal DC input voltages and nominal operating temperature. Seagate Laptop HDD Product Manual, Rev. D... -
Page 13: Start/Stop Times
During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels Standby power is measured at steady state (after 200ms from transition) Read/Write: Avg. Read/Write operation at OD for 32 sectors. Seagate Laptop HDD Product Manual, Rev. D... -
Page 14: Conducted Noise
<5 s Environmental Specifications This section provides the temperature, humidity, shock, and vibration specifications for Seagate Mobile HDD drives. Ambient temperature is defined as the temperature of the environment immediately surrounding the drive. Above 1000 feet (305 meters), the maximum temperature is derated linearly by 1°C every 1000 feet. -
Page 15: Shock
Test for prominent discrete tones (PDTs) Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses the lower limit for the threshold curve* to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards. -
Page 16: Electromagnetic Immunity
From this page, click on the “Is my Drive under Warranty” link. The following are required to be provided: the drive serial number, model number (or part number) and country of purchase. The system will display the warranty information for the drive. Seagate Laptop HDD Product Manual, Rev. D... -
Page 17: Agency Certification
Emission levels are defined by EN 55022, Class B and the immunity levels are defined by EN 55024. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if necessary) and terminators on all unused I/O ports. -
Page 18: Environmental Protection
Users should use caution exposing any electronic components to uncontrolled chemical pollutants and corrosive chemicals as electronic drive component reliability can be affected by the installation environment. The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%. -
Page 19: Unpacking, Configuring And Mounting The Drive
For installations which require cables, users can connect the drive as shown in1. Figure 1 Attaching SATA Cabling Signal connector Power connector Signal cable Power cable Each cable is keyed to ensure correct orientation. Laptop HDD drives support latching SATA connectors. Seagate Laptop HDD Product Manual, Rev. D... -
Page 20: Drive Mounting
Operating: no performance degradation, emitted noise, 10 mm probe: 2.0kgf (typical) mechanical damage, or hard errors Non-operating: no hard errors 10 mm probe: maximum 2.0kgf (instantaneous) Figure 2 Mounting Dimensions (for 1-disk models) Seagate Laptop HDD Product Manual, Rev. D... -
Page 21: About (Sed) Self-Encrypting Drives
The Trusted Computing Group (TCG) is an organization sponsored and operated by companies in the computer, storage and digital communications industry. Seagate's SED models comply with the standards published by the TCG. To use the security features in the drive, the host must be capable of constructing and issuing the following two SATA commands: •... -
Page 22: Ata Enhanced Security
Since the drive overwrites the old key with the new one, and keeps no history of key changes, the user data can never be recovered. This is tantamount to an instantaneous data erase and is very useful if the drive is to be scrapped or redispositioned. Seagate Laptop HDD Product Manual, Rev. D... -
Page 23: Authenticated Firmware Download
In addition to providing a locking mechanism to prevent unwanted firmware download attempts, the drive also only accepts download files which have been cryptographically signed by the appropriate Seagate Design Center. Three conditions must be met before the drive will allow the download operation: The download must be an SED file. -
Page 24: Serial Ata (Sata) Interface
5V power, pre-charge, 2nd mate Power 5V power 5V power Ground 2nd mate Ground or LED signal If grounded, drive does not use deferred spin Ground 1st mate 12V power, pre-charge, 2nd mate 12V power 12V power Seagate Laptop HDD Product Manual, Rev. D... -
Page 25: Supported Ata Commands
Read Long with Retries Read Long without Retries Read Multiple Read Multiple Extended Read Native Max Address Read Native Max Address Extended Read Sectors Read Sectors Extended Read Sectors without Retries Read Verify Sectors Seagate Laptop HDD Product Manual, Rev. D... - Page 26 Trusted Receive (SED only) Trusted Receive DMA (SED only) Trusted Send (SED only) Trusted Send DMA (SED only) Write Buffer Write DMA Write DMA Extended Write DMA without Retries Write Long with Retries Seagate Laptop HDD Product Manual, Rev. D...
- Page 27 ATA-standard power-management commands Check Power Mode Idle Idle Immediate Sleep Standby Standby Immediate ATA-standard security commands Security Set Password Security Unlock Security Erase Prepare Security Erase Unit Security Freeze Lock Security Disable Password Seagate Laptop HDD Product Manual, Rev. D...
-
Page 28: Identify Device Command
Standard Standby timer, IORDY supported and may be disabled 2F00 Capabilities 4000 PIO data-transfer cycle timing mode 0200 Retired 0200 Words 54–58, 64–70 and 88 are valid 0007 Number of current logical cylinders xxxx Number of current logical heads xxxx Seagate Laptop HDD Product Manual, Rev. D... - Page 29 Command sets supported 7D69 Command sets support extension 61E3 Command sets enabled 7469 Command sets enabled BC49 Command sets enable extension 61E3 Ultra DMA support and current mode (see note following this table) xx7F Seagate Laptop HDD Product Manual, Rev. D...
- Page 30 ATA-reserved 0000 Transport major version number 101F 223–254 ATA-reserved 0000 Integrity word xxA5 See the bit descriptions below for words 63, 88 and 93 of the Identify Drive data. (on next page) Note Seagate Laptop HDD Product Manual, Rev. D...
- Page 31 Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Word 93 1 = 80-conductor cable detected, CBLID above VIH 0 = 40-conductor cable detected, CBLID below VIL Seagate Laptop HDD Product Manual, Rev. D...
-
Page 32: Set Features Command
Disable the Free Fall Protection feature (41 above enables the Free Fall Protection feature) Report full capacity available At power-on, or after a hardware or software reset, the default values of the features are as indicated above Note Seagate Laptop HDD Product Manual, Rev. D... -
Page 33: S.m.a.r.t. Commands
) that eliminates unnecessary drive returns. The diagnostic software ships with all new drives and is also available at: http://www.seagate.com/support/downloads/seatools/. This drive is shipped with S.M.A.R.T. features disabled. Users must have a recent BIOS or software package that supports S.M.A.R.T. to enable this feature. - Page 34 ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100772113, Rev. D...