Related Manuals for Seagate ST5000AS0011
Summary of Contents for Seagate ST5000AS0011
- Page 1 Product Manual Seagate Archive HDD ® Standard Model Self-Encryption Drive Model ST5000AS0011 ST5000AS0001 100743737 Rev. D April 2015...
- Page 2 Publication number: 100743737, Rev. D April 2015 Seagate, Seagate Technology and the Spiral logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. SmartAlign, AcuTrac and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries.
-
Page 3: Table Of Contents
Drive Locking............18 Seagate Archive HDD Product Manual, Rev. D... - Page 4 S.M.A.R.T. commands ..........28 Seagate Archive HDD Product Manual, Rev. D...
- Page 5 Mounting dimensions ............16 Seagate Archive HDD Product Manual, Rev. D...
-
Page 6: Seagate Technology Support Services
Authorized Service Centers For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/data-recovery-services/ For Seagate OEM and Distribution partner portal, visit: http://www.seagate.com/partners/ For Seagate reseller portal, visit: http://www.seagate.com/partners/my-spp-dashboard/ Seagate Archive HDD Product Manual, Rev. D... -
Page 7: Introduction
• Native Command Queuing with command ordering to increase performance in demanding applications. • Full-track multiple-sector transfer capability without local processor intervention. • Seagate AcuTrac™ servo technology delivers dependable performance even with hard drive track widths of only 75 nanometers. -
Page 8: Drive Specifications
0 to 60°C (operating) Ambient Temperature -40 to 70°C (non-operating) 20°C (operating) Temperature gradient (°C per hour max) 30°C (non-operating) 5% to 90% (operating) Relative humidity 5% to 95% (non-operating) Relative humidity gradient (per hour max) Seagate Archive HDD Product Manual, Rev. D... - Page 9 * One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. ** During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate Archive HDD Product Manual, Rev. D...
-
Page 10: Formatted Capacity
600 (Ultra DMA mode 5) Physical characteristics Height (max) 26.11mm / 1.028 in Width (max) 101.85mm / 4.010 in Length (max) 147.00mm / 5.787 in Weight: (maximum) 655g (1.44 lb) Cache buffer 128MB (129,536KB) Seagate Archive HDD Product Manual, Rev. D... -
Page 11: Seek Time
Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in a random track location. • Standby mode During Standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/ write electronics are in power-down mode. Seagate Archive HDD Product Manual, Rev. D... - Page 12 Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in a random track location. • EPC Idle/Standby/Sleep mode The current is measured in the desired EPC idle/standby state. Seagate Archive HDD Product Manual, Rev. D...
-
Page 13: Figure 1 Typical 5Tb Model 5V - 6Gb/S Startup And Operation Current Profile
2.7.1.1 Typical current profiles 5TB model current profile Figure 1 Typical 5TB model 5V - 6Gb/s startup and operation current profile Figure 2 Typical 5TB model 12V - 6Gb/s startup and operation current profile Seagate Archive HDD Product Manual, Rev. D... -
Page 14: Conducted Noise
2.8.3.1 Relative humidity Operating 5% to 90% non-condensing (30% per hour max) Nonoperating 5% to 95% non-condensing (30% per hour max) 2.8.3.2 Wet bulb temperature Operating 30°C (86°F max) Non-operating 40°C (104°F max) Seagate Archive HDD Product Manual, Rev. D... -
Page 15: Altitude
The maximum non-operating vibration levels that the drive may experience without incurring physical damage or degradation in performance when subsequently put into operation are specified below. 5Hz to 22Hz 3.0 Gs (Limited displacement) 22Hz to 350Hz 3.0 Gs 350Hz to 500Hz 3.0 Gs Seagate Archive HDD Product Manual, Rev. D... -
Page 16: Acoustics
Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses this threshold curve (originated in ISO 389- 7) to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards. -
Page 17: Reliability
EN 55022, Class B and the immunity levels are defined by EN 55024. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. -
Page 18: Fcc Verification
As a subassembly, no Federal Communications Commission verification or certification of the device is required. Seagate has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disk drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules. -
Page 19: Environmental Protection
The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%. -
Page 20: Configuring And Mounting The Drive
For installations which require cables, users can connect the drive as illustrated in Figure 3 Figure 3 Attaching SATA cabling Signal connector Power connector Signal cable Power cable Each cable is keyed to ensure correct orientation. Seagate Archive HDD drives support latching SATA connectors. Seagate Archive HDD Product Manual, Rev. D... -
Page 21: Drive Mounting
These dimensions conform to the Small Form Factor Standard documented Note in SFF-8301 and SFF-8323 found at www.sffcommittee.org Figure 4 Mounting dimensions This image may not be representative of the actual drive. Note Seagate Archive HDD Product Manual, Rev. D... -
Page 22: About (Sed) Self-Encrypting Drives
The Trusted Computing Group (TCG) is an organization sponsored and operated by companies in the computer, storage and digital communications industry. Seagate's SED models comply with the standards published by the TCG. To use the security features in the drive, the host must be capable of constructing and issuing the following two SATA commands: ... -
Page 23: Default Password
Each data band has its own drive-generated encryption key. The host may change the Encryption Key (see Cryptographic Erase ) or the password when required. The bands should be aligned to 4K LBA boundaries. Seagate Archive HDD Product Manual, Rev. D... -
Page 24: Cryptographic Erase
In addition to providing a locking mechanism to prevent unwanted firmware download attempts, the drive also only accepts download files which have been cryptographically signed by the appropriate Seagate Design Center. Three conditions must be met before the drive will allow the download operation: 1. -
Page 25: Sata Interface
Hot-Plug compatibility Seagate Archive HDD drives incorporate connectors which enable users to hot plug these drives in accordance with the SATA Revision 3.0 specification. This specification can be downloaded from www.serialata.org. The drive motor must come to a complete stop (Ready to spindle stop time indicated in Section 2.6) Caution prior to changing the plane of operation.This time is required to insure data integrity. -
Page 26: Supported Ata Commands
Read Native Max Address Extended Read Sectors Read Sectors Extended Read Sectors Without Retries Read Verify Sectors Read Verify Sectors Extended Read Verify Sectors Without Retries Recalibrate Security Disable Password Security Erase Prepare Security Erase Unit Seagate Archive HDD Product Manual, Rev. D... - Page 27 Write DMA Extended Write DMA FUA Extended Write DMA Without Retries Write Log Extended Write Multiple Write Multiple Extended Write Multiple FUA Extended Write Sectors Write Sectors Without Retries Write Sectors Extended Write Uncorrectable Seagate Archive HDD Product Manual, Rev. D...
-
Page 28: Identify Device Command
Words 54–58, 64–70 and 88 are valid 0007 Number of current logical cylinders xxxx Number of current logical heads xxxx Number of current logical sectors per logical track xxxx 57–58 Current capacity in sectors xxxx Seagate Archive HDD Product Manual, Rev. D... - Page 29 Ultra DMA support and current mode (see note following this table) xx7F Security erase time 0039 Enhanced security erase time 0039 Master password revision code FFFE Hardware reset value xxxx Automatic acoustic management 8080 Seagate Archive HDD Product Manual, Rev. D...
- Page 30 GPL feature set is supported. WRITE DMA FUA EXT and WRITE MULTIPLE FUA EXT commands are supported. WRITE DMA QUEUED FUA EXT command is supported. 64-bit World Wide Name is supported. 9-10 Obsolete. Seagate Archive HDD Product Manual, Rev. D...
- Page 31 Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Seagate Archive HDD Product Manual, Rev. D...
-
Page 32: Set Features Command
Disable use of SATA features Enable read look-ahead (read cache) feature (default) Report full capacity available At power-on, or after a hardware or software reset, the Note default values of the features are as indicated above. Seagate Archive HDD Product Manual, Rev. D... -
Page 33: Commands
S.M.A.R.T. Enable Operations S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x 04 (abort) is written to the Error register. Seagate Archive HDD Product Manual, Rev. D... - Page 34 ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100743737, Rev. D...