NEC N8151-74 User Manual page 82

72
Take off the disk from the Built-in DVD-RAM drive and put it into the attached
1.
plastic protection case to save it.
Note that an excess force may not be added to the disk.
Exit the system, turn off the power of the computer, and pull out the power cord
2.
from the AC inlet.
Remove the covers of the computer.
3.
Disconnect the DC power and interface cables connected to the Built-in
4.
DVD-RAM drive.
Remove the Built-in DVD-RAM drive from the computer.
5.
If the rails are attached to the Built-in DVD-RAM drive, take off the Built-in
DVD-RAM drive from the computer by the procedure shown in the figure below.
Remove the rails from the Built-in DVD-RAM drive if they are attached to the
6.
Built-in DVD-RAM drive.
Put the Built-in DVD-RAM drive into the package which contained the Built-in
7.
DVD-RAM drive previously and fix the Built-in DVD-RAM drive with the attached
protectors.