Wire The Remote Controller; Requirements For Installing Two Remote Controllers - Toshiba RB-RWS21-E Installation Manual

 Wire the remote controller
Wiring diagram
Terminal block for the remote control wiring on the indoor unit
 Requirements for installing two remote controllers
In the dual remote controller system, one or more units are operated from two remote controllers. (Up to two remote
controllers can be installed.)
Set the Follower remote controller
Set from "6. Header/Follower" in "Initial setting" on the MENU screen.
For details, refer to the page 16.
Install the remote controllers
For the dual remote controller system, install the remote controllers as follows:
Set one remote controller as the Header remote controller.
(The remote controllers are set as "Header remote controller" as factory default.)
A
B
* Terminals of A and B
have no polarity.
2
* Use wire of 0.5 mm to 2.0 mm
* A crimp-style terminal cannot be used.
Remote control wiring (procured locally)
A
Remote controller
B
Terminal block for
the remote control
wiring
2
.
– 7 –
Installation Manual