NordicTrack Elite zi User Manual page 7

2. Identify the Right Upright (88). See the inset
drawing. Tie the wire tie in the Right Upright se-
curely around the end of the Upright Wire (86).
With the help of a second person, hold the Right
Upright near the Right Base Cover (117). Then,
pull the other end of the wire tie up through the
bottom of the Right Upright until the Upright Wire
is routed completely through the Right Upright.
Gently pull up on the Upright Wire (86) as you
set the Right Upright (88) on the Base (115) in-
side the Right Base Cover (117). Be careful not
to pinch the Upright Wire.
Attach the Right Upright (88) to the Base (115)
with two 3/8" x 3 3/4" Patch Bolts (2) and two
3/8" Star Washers (8). Do not tighten the
Patch Bolts yet. Note: It may be necessary to
tip the top of the Right Upright forward slightly
as you thread the Patch Bolts into the Right
Upright.
3. Set the Left Upright (85) on the Base (115) in-
side the Left Base Cover (81).
Attach the Left Upright (85) to the Base (115)
with two 3/8" x 3 3/4" Patch Bolts (2) and two
3/8" Star Washers (8). Do not tighten the
Patch Bolts yet. Note: It may be necessary to
tip the top of the Left Upright forward slightly as
you thread the Patch Bolts into the Left Upright.
With the help of a second person, lower the
treadmill off the cardboard stands. The stands
will be used in assembly step 9.
2
86
Wire
88
117
3
7
88
86
Tie
Wire
Tie
115
8
2
85
115
81
Cardboard
Stands
8
2