Wiring Connections; Main Harness (H1), 6-Pin Connector; Auxiliary/Shutdown Harness (H2), 24-Pin Connector - Directed Electronics Viper 4104 Installation Manual

Wiring Connections

Main Harness (H1), 6-pin connector

H1/1 RED (+)12VDC CONSTANT INPUT
H1/2 BLACK (-) CHASSIS GROUND
H1/3 BROWN (-) 200mA HORN HONK OUTPUT
H1/4 WHITE/BROWN LIGHT FLASH ISOLATION WIRE - PIN 87a light flash relay
H1/5 WHITE PIN 30 of LIGHT FLASH RELAY
H1/6 ORANGE 500 mA GROUND WHEN ARMED OUTPUT

Auxiliary/Shutdown Harness (H2), 24-pin connector

H2/1 PNK/WHITE
H2/2 BLACK/WHITE
H2/3 BLUE/WHITE
H2/4 GREEN/BLACK
H2/5 RED/WHITE
H2/6 GREEN
H2/7 BLACK/YELLOW
H2/8 EMPTY
H2/9 DARK BLUE
H2/10 PINK
H2/11 WHITE/BLACK
H2/12 VIOLET
H2/13 WHITE/VIOLET
H2/14 VIOLET/BLACK
H2/15 ORANGE/BLACK
H2/16 BROWN
H2/17 GRAY
H2/18 VIOLET/YELLOW
H2/19
BLUE**
H2/20 GRAY/BLACK
H2/21 WHITE/BLUE
H2/22 ORANGE
H2/23 VIOLET/WHITE
H2/24 GREEN/WHITE
*The Normally Closed setting will only work if one of the vehicle's doors is connected. If more than one door
is to be monitored, then it is recommended to use the Xpresskit DTIMAZDA or tech tip # 1921 on www.di-
rectechs.com to interface with these types of vehicles.
**This optional input can be connected to the horn circuit (+ or -). When this wire receives input for a minimum of
.5 seconds, the system reports a trigger on the 2-way remote. This is useful on vehicles that have a factory security
system that can be armed/disarmed with the Directed system. This system will not report that a zone has been
triggered when unlocking with the 2-way remote. This feature is not available on the 1-way remote.
6
(-) 200mA FLEX RELAY CONTROL OUTPUT
(-) NEUTRAL SAFETY INPUT
(-) 200mA 2ND STATUS /REAR DEFOGGER OUTPUT
(-) 200mA FACTORY ALARM DISARM OUTPUT
(-) 200mA TRUNK RELEASE OUTPUT
(-) DOOR INPUT*
(-) 200mA DOME LIGHT OUTPUT
------------------------------------
(-) 200mA STATUS OUTPUT
(-) 200mA IGNITION 1 OUTPUT
(-) 200mA AUX 3 OUTPUT
(+) DOOR INPUT
(-) 200mA AUX 1 OUTPUT
(-) 200mA AUX 2 OUTPUT
(-) 200mA AUX 4 OUTPUT
(+) BRAKE SHUTDOWN INPUT
(-) HOOD PIN INPUT (NC OR NO)
(-) 200mA STARTER OUTPUT
FACTORY HORN INPUT (Use Jumper to set polarity)
(-) DIESEL WAIT TO START INPUT
ACTIVATION INPUT
(-) 200mA ACCESSORY OUTPUT
TACHOMETER INPUT
(-) 200mA FACTORY ALARM ARM OUTPUT
© 2011 Directed Electronics. All rights reserved.