Wired Remote Controller - Toshiba RAV-SM404MUT-E Owner's Manual

Compact 4-way Type
3

Wired Remote Controller

This remote controller can control the operation of up to 8 indoor units.
Display section
In the display illustration below all the icons are shown. When the unit is in operation,
only relevant icons will be displayed.
• When the leak breaker is turned on for the first time,
part of the remote controller.
• While this icon is flashing, the model is being automatically confirmed.
Wait till icon has disappeared to use the remote controller.
3 4
1
2
5
6
9
19
1
Operation mode
The selected operation mode is displayed.
2
Error display
Displayed while the protective device works or a error
occurs.
3
SETTING display
Displayed during setup of the timer or other settings.
4
TEST run display
Displayed during a test run.
5
Timer display
When an error occurs, error code is displayed.
6
Timer mode display
The selected timer mode is displayed.
7
Louver position display
Displays louver position.
8
Swing display
Displayed during up / down movement of the louver.
9-EN
Owner's Manual
flashes on the display
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
13
7 8 14 18
12
11
15
16
10
17
9
Filter display
Reminder to clean the air filter.
10
Fan speed display
The selected fan speed mode is displayed.
(Auto)
(High)
(Med.)
(Low)
11
Set temperature display
The selected set temperature is displayed.
12
Power saving mode display
Limits compressor speed (capacity) to save energy.
Compact 4-way Type
– 5 –
1
2
Display
5
section
6
9
Operation
section
19
13
UNIT No. display
Displays the number of the indoor unit selected.
Also displays error code of indoor and outdoor units.
14
Central control display
Displayed when the air conditioner is used under the
central control in combination with a central control
remote controller.
In case the remote controller is disabled by the central
control system,
The button operation is not accepted.
Even when ON / OFF, MODE, or TEMP. button is
20
pushed, and the button operation is not accepted.
(Settings made by the remote controller vary with the
central control mode. For details, refer to the Owner's
Manual of the central control remote controller.)
14 13
7 8 18
3 4 12
10
15
Remote controller sensor display
Displayed while the sensor of the remote controller is
used.
16
Pre-heat display
Displayed when the heating mode is energized or
defrost cycle is initiated.
While this icon is displayed, the indoor fan stops.
17
No function display
flashes.
Displayed when the function requested is not available
on that model.
18
Self clean operation display
Displayed during self clean operation to dry the indoor
heat exchanger.
19
Service display
20
Operation ready display
This display appears on some models.
Owner's Manual
11
15
20
16
17
10-EN