Automatic Ice Maker-Freezer - Kenmore 253.7041 Use & Care Manual

Automatic Ice Maker - Freezer
Operation & Care of the Freezer
Ice Maker
After the refrigerator is installed properly,
the ice maker can produce ice within 24
hours. It can completely fill the ice bin in
about three days.
When using the ice maker for the first
time and in order for the ice maker to
work properly, it is necessary to clear air
from water filter tubing. Once ice maker
begins making ice, allow the bucket to fill
completely, then discard the first TWO
FULL buckets of ice. It will take at least
two days to completely fill the bucket on
regular ice making mode or 1½ days on
fast ice mode.
The ice maker produces approximately
four pounds of ice every 24 hours
depending on usage conditions.
IMPORTANT
Your ice maker is turned on at the
factory so it can work as soon as you
install your refrigerator. If you cannot
connect a water supply, lift the ice
maker's wire signal arm to turn it off.
Otherwise, the ice maker's fill valve may
make a loud chattering noise when it
attempts to operate without water.
Turning the Ice Maker On and Off
Ice
production
is
controlled
by lifting/
lowering
the ice
maker's
wire
signal
arm. To
gain access to the ice maker, pull the
freezer drawer out. Lift the wire signal
arm to turn the ice maker OFF and lower
the wire signal arm to turn it ON.
Ice maker tips
• If your refrigerator is not connected to
a water supply or the water supply is
turned off, turn off the ice maker by
lifting wire signal arm.
• The following sounds are normal when
• Ice cubes stored too long may develop
Quick Ice Function
Your refrigerator is equipped with a Quick
Ice Function, that increases ice production.
This function terminates automatically.
If the water supply to your refrigerator is
softened, be sure the softener is properly
maintained. Chemicals from a water
softener can damage the ice maker.
Cleaning the Ice Maker
Clean the ice maker and ice bin at regular
intervals, especially prior to vacation or moving.
1. Turn off the ice maker.
2. Remove the ice bin.
3. Empty and carefully clean the ice bin
4. Allow the ice bin to dry completely
5. Replace the ice bin. Turn the ice maker on.
ON
Remove and empty the ice bin if:
• An extended power failure (one hour or
OFF
Remove the ice bin and shake to loosen
the cubes or clean as explained above.
Wire
Signal Arm
NEVER use an ice pick or similar sharp
instrument to break up the ice. This
could damage the ice bin.
To loosen stuck ice, use warm water.
Before replacing the ice bin, make sure
it is completely dry.
19
the ice maker is operating:
- Motor running
- Ice dropping into ice bin
- Water valve opening or closing
- Running water
an odd flavor. Empty the ice bin as
explained below.
CAUTION
with mild detergent. Do not use harsh or
abrasive cleaners. Rinse with clean water.
before replacing in the freezer.
longer) causes ice cubes in the ice bin
to melt and freeze together.
CAUTION