Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
STEP 4
Remove the paper covering from the foam tape inside the FRONT COVER(3) and REAR COVER(4).
Place the FRONT COVER(3) over the end of the FRONT FRAME(1). Place the REAR COVER(4) over
the end of the REAR FRAME(2). Press the covers securely in place.
NOTE: The securing SCREWS(M6x1x35mm)(36) for the PULLEY SET(22) on each side may need
to be loosened to allow the REAR COVER(4) to fit securely over the frame. Refer to the inset
illustration. When retightening the screws for the PULLEY SETS(22) do not over tighten. The
PULLEY SETS(22) should swivel freely.
STEP 5
Insert the FOOTBAR(5) into the mounting holes located on the FRONT FRAME(1). The FOOTBAR(5)
should pass through the FRONT COVER(3) and the FRONT FRAME(1) all the way to the bottom.
STEP 6
Insert the FOAM PAD ASSEMBLIES(17) into the holes located on the CARRIAGE(7). Place the HAND/
FOOT STRAPS(20) onto the FOAM PAD ASSEMBLIES(17) for storage.
8
Advertisement
Table of Contents
