Storage; Maintenance - Stamina 55-4287 Owner's Manual

STORAGE

1. To store the AeroPilates® Reformer 287, simply keep it in a clean dry place.
2. The FRONT FRAME(1) of the AeroPilates® Reformer 287 has built-in WHEELS(24) for easy
moving. To move, be sure at least one of the tension cords is attached to prevent the CARRIAGE(7)
from sliding, then lift from the end of the REAR FRAME(2) and roll.
3. The AeroPilates® Reformer 287 folds for storage. To fold, be sure no tension cords are attached
and slide the CARRIAGE(7) to the end of the REAR FRAME(2). Remove the FOOTBAR(5) and
FOAM PAD ASSEMBLIES(17), then lift the AeroPilates® Reformer 287 onto its side with the
LOCKING PIN(26) side up. With the machine hinging in the middle, move the FRONT FRAME(1)
toward the REAR FRAME(2) until the frame ends meet. Insert the LOCKING PIN(26) into the hole in
the REAR FRAME(2), and the AeroPilates® Reformer 287 is ready to store.
CAUTION Keep hands clear of the hinge when folding and unfolding the unit.
!

MAINTENANCE

The safety and integrity designed into the AeroPilates® Reformer 287 can only be maintained when the
AeroPilates® Reformer 287 is regularly examined for damage and wear. Special attention should be
given to the following:
1. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
2. Worn or damaged components should be replaced immediately or the AeroPilates® Reformer 287
should be removed from service until repair is made.
3. Verify that the CAUTION LABEL(50) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(50) if it is missing or damaged.
4. Verify that the ROPES(18) are properly installed on the PULLEY SETS(22).
5. Check the condition of the ROPES(18) and replace if they are frayed or worn.
6. Check the TENSION CORDS(10). If any of the TENSION CORDS(10) are stretched and loose, re-tie
the knot on the end of the cord. Replace TENSION CORDS(10) that are frayed or worn.
7. Check the PULLEY SETS(22) for excessive wear. Replace worn PULLEY SETS(22).
8. Check the HAND/FOOT STRAPS(20) for damage. Replace damaged parts.
9. Check the FOAM SLEEVE(6) and FOAM PADS(17) and replace if damaged or worn.
10. Check the STOP PLATES(27) for looseness or damage and replace any damaged parts.
11. Check the CUSHION(14) and replace if it is damaged or worn.
12. Check and clean the ROLLERS(8) and the rolling surfaces on the rails. Clean by wiping with a dry
cloth.
13. Only Stamina Products supplied components shall be used to maintain/repair the AeroPilates®
Reformer 287.
14. Keep your AeroPilates® Reformer 287 clean by wiping it off with an absorbent cloth after use.
13