Assembly Instructions - Stamina 55-4287 Owner's Manual

ASSEMBLY INSTRUCTIONS

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove
all packing materials from your area and place them back into the box. Do not dispose of the packing
materials until assembly is completed. Read each step carefully before beginning. If you are missing
a part, please go to staminaproducts.com under the Service section and order the part needed,
e-mail us at customer.care@staminaproducts.com, or call us toll free at 1-800-375-7520 (in the U.S.).
Our Customer Care Staff is available to assist you from 7:30 A.M. to 5:00 P.M. (Central Time) Monday
through Thursday and 8:00 A.M. to 3:00 P.M. (Central Time) on Friday.
STEP 1
Remove your AeroPilates® Reformer 287 from its packaging, placing the product on its side with
the LOCKING PIN(26) side upward. Remove the LOCKING PIN(26) and unfold the MAIN FRAME
ASSEMBLY separating the half that has the attached LOCKING PIN(26). When completed, the frame
should form a "V" with the frame ends separated approximately three feet.
STEP 2
Attach the four RUBBER FEET(25) to the FRONT FRAME(1) and REAR FRAME(2) with ROUND HEAD
SCREWS(M5x0.8x35mm)(37). The ROUND HEAD SCREWS(M5X0.8X35mm)(37) are already in the
RUBBER FEET(25). Attach the WHEELS(24) to the FRONT FRAME(1) with WASHERS(M8)(46) and
NYLOCK NUTS(M8x1.25)(40).
STEP 3
Unfold your AeroPilates® Reformer 287 to a flat position by moving the FRONT FRAME(1) away
from the platform end of the REAR FRAME(2) in a clockwise position until fully extended. Lower the
AeroPilates® Reformer 287 so all four RUBBER FEET(25) are flat on the floor.
7