Hitachi RAS-S18CAK Instruction Manual page 6

NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT
REMOTE CONTROLLER
This controls the operation of the indoor unit. Signal range to reach indoor unit is about 7 meters. If
inverter lamp is used, the range of control may be shorter.
This unit can be À xed on a wall using the À xture provided. Before À xing it, make sure the indoor unit
can be controlled from the remote controller.
Transmission sign
●
The transmission sign blinks when a signal is sent.
Display
●
This indicates the room temperature selected, timer status, function
and intensity of circulation selected.
CIRCULATION button
●
Use this button to set air circulation in the room or start operation.
DEHUMIDIFYING button
●
Use this button to reduce humidity in the room or start operation.
COOLING button
●
Use this button to set cooling mode in the room or start operation.
RESET button
●
STOP button
●
Press this button to stop operation only.
SLEEP button
●
Use this button to set the sleep timer.
FAN SPEED selector
●
This determines the fan speed. Each time you press this button,
the intensity of circulation will change from
to (MED) to
AUTO SWING button
●
Controls the angle of the horizontal air deÁ ector.
TEMPERATURE button
●
Use this button to raise or lower the temperature setting. (Keep
pressed, and the value will change more quickly.)
OFF-TIMER button
●
ON-TIMER button
●
Precautions for Use
Do not put the remote controller in the following places.
●
In direct sunlight.
●
In the vicinity of a heater.
●
Handle the remote controller carefully. Do not drop it on the
●
Á oor, and protect it from water.
Once the outdoor unit stops, it will not restart for about 3
●
minutes (unless you turn the power switch off and on or unplug
the power cord and plug it in again).
This is to protect the device and does not indicate a failure.
– 6 –
(LOW)
Select the turn OFF time.
Select the turn ON time.
(AUTO) to (HI)