General Use And Safety; Recommended Touchpanel Cleaning - Crestron ST-1550C Operation Manual

Crestron ST-1550C
Interface
Operations Guide – DOC. 6096A
Power Up On Last Page
The Power Up On Last Page button lets you specify which screen appears when
unit is powered up. When set to ON (indicated by the button's background color
changing to blue), the last screen to be displayed reappears and all feedback is
restored when the touchpanel is reactivated. When set to OFF (the button's text
assumes the same shade as all the other buttons on the screen), the first page of the
project appears when the touchpanel is activated.
Interface Screen
The touchpanel communicates with an ST-CP (for SmarTouch) or other Crestron
control system (for Cresnet) via wireless RF (through a CNRFGWA gateway). To
do so, the touchpanel Cresnet ID and RF ID settings and those assigned in the
control system program must match. To set the Cresnet ID and RF ID, select the
Interface button from the Advanced Settings screen and display the Interface screen,
shown to the left of this paragraph.
The CRESNET ID network identity number (NET ID), displayed in the top left
corner of the Interface screen, is only used during screen uploads to the touchpanel,
and consists of a two-digit hexadecimal number. "03" is shown as an example in the
illustration and happens to be the default. The down and up arrow buttons decrease
and increase the NET ID by one, respectively (i.e., 01, 02, 03, . . . FE).
The radio frequency identity number (RF ID), displayed in the top right corner of the
Interface screen, is necessary to secure RF communications such that controls can be
activated from the touchpanel. The RF ID consists of a two-digit hexadecimal
number. The touchpanel can be set to one of fifteen numbers; "10" is shown as an
example in the illustration and happens to be the default. The down and up arrow
buttons decrease and increase the RF ID most significant digit by one, respectively
(i.e., 10, 20, 30, ..., F0). The RF ID of the unit must match the RF ID specified in
the SIMPL Windows program.
NOTE: Do not set the RF ID to "00"; it is not supported in SIMPL Windows.
After the Cresnet ID and RF ID settings have been verified, touch the RETURN
button, located at the bottom of the screen, to save the settings and display the
Advanced Settings Screen.

General Use and Safety

WARNING: To avoid shock hazard and possible damage to the unit, do not use
touchpanel in rain or expose it to unnecessary moisture.

Recommended Touchpanel Cleaning

Keep the surface of the touchscreen free of dirt, dust, or other materials that could
degrade optical properties. Long-term contact with abrasive materials can scratch the
surface that may detrimentally affect image quality.
For best cleaning results, use a clean, damp, non-abrasive cloth with any
commercially available non-ammonia glass cleaner. The surrounding plastic
enclosure may not provide a completely watertight seal. Therefore, apply cleaning
solution to the cloth rather than the surface of the touchscreen. Wipe touchscreen
clean and avoid leakage of moisture beneath panels.
1-Way Wireless RF Touchpanel
1-Way Wireless RF Touchpanel: ST-1550C • 11