Mitsubishi DLP NW31U-EST User Manual page 64

Advanced features (continued)
Connection
For details of the connection, see "LAN control UTILITY operation manual" in the CD-ROM.
When STANDBY MODE of the INSTALLATION menu of the projector is set to LOW, the network function is
disabled. To enable the network function, set STANDBY MODE to STANDARD or LAN. (See page 28.)
Confi gure the initial network settings fi rst.
You can confi gure the initial settings using the projector menu (see pages 40 to 45) or ProjectorView Global+ or
ProjectorView. For details of ProjectorView Global+ and ProjectorView, see "LAN control UTILITY operation manual" in
the CD-ROM.
Using the User Manual
The User Manual for LAN Control Utility is prepared in the Portable Document Format (PDF) in the CD-ROM.
Opening the User Manual:
1. Load the CD-ROM into the CD-ROM drive.
2. Open CD-ROM "PROJECTOR."
3. Double-click on "MANUAL_LAN.HTML" within the CD-ROM. A language selection list for the User Manual will be
displayed.
4. Move the mouse pointer to the desired language and click.
PJLink™ supported commands
The table below shows commands to control the projector using the PJLink™ protocol.
Command Description
POWR Power control
POWR ? Inquiry about the power state
INPT Input switching
INPT ? Inquiry about input switching
AVMT Mute control
AVMT ? Inquiry about the mute state
ERST ? Inquiry about the error state
LAMP ? Inquiry about the lamp state
INST ? Inquiry about the available inputs
NAME ? Inquiry about the projector name
INF1 ? Inquiry about the manufacturer name
INF2 ? Inquiry about the model name
INF0 ? Inquiry about other information
CLSS ? Inquiry about the class information
• This projector is fully compliant to the specifi cations of JBMIA PJLink™ Class 1. It supports all the commands defi ned by
PJLink™ Class 1, and the compliance has been verifi ed with the PJLink™ standard specifi cations Version 1.0.
Remark (Parameter)
0 = Standby
1 = Power on
0 = Standby
1 = Power on
2 = Cooling down
3 = Warming up
11 = COMPUTER1 12 = COMPUTER2
21 = VIDEO 22 = S-VIDEO
31 = HDMI 41 = USB VIEWER
30 = Video and audio mute disable
31 = Video and audio mute enable
1st byte: Fan error, 0 or 2
2nd byte: Light source error, 0 or 2
3rd byte: Temperature error, 0 or 2
4th byte: Cover open error, 0 or 2
5th byte: Always 0
6th byte: Other error, 0 or 2
0 to 2 mean as follows:
0 = No error detected, 1 = Warning, 2 = Error
1st value (1 to 5 digits): Cumulative light source operating time (This item
shows total light source operating hours.)
2nd value: 0 = Light source off, 1 = Light source on
The following value is returned.
"11 12 21 22 31 41 51"
The projector name set on the NETWORK menu or the Crestron
RoomView is returned.
"MITSUBISHI" is returned.
"NW31U-EST" is returned.
No other information is available. No parameter is returned.
"1" is returned.
EN-64
51 = LAN DISPLAY