Mitsubishi DLP NW31U-EST User Manual page 20

Basic operation (continued)
To stop projecting:
8. Press the POWER button.
• A confi rmation message is displayed.
• To cancel the procedure, leave the projector for a while or press any button except the POWER button.
9. Press the POWER button again.
• The light goes out and the projector goes into a standby mode. In this standby mode, the STATUS indicator
may blink green about 1 second and then go out.
10. Unplug the power cord from the outlet.
• The POWER indicator will go out. It may take about a half minute for the POWER indicator to go out.
• If necessary, disconnect the cables from the computer after unplugging the power cord.
Direct Power OFF
You can turn off this projector just by unplugging the power cord without pressing the POWER button.
• Before shutting down the projector, be sure to close the menu screen. If you shut down the projector without
closing the menu, the setting data of the menu may not be saved.
• Don't shut down the projector while you are changing the NETWORK menu settings or projector's settings via
network connection.
Volume from the speaker
Press the VOLUME + or - button on the remote control or VOLUME button on the projector. The volume control bar
will appear on the screen. Press the VOLUME +, -,  or  button while the volume control bar is displayed to adjust
the volume.
• The volume control bar will also appear by pressing the ENTER button while the balance control bar is displayed.
VOLUME 16
ENTER : BALANCE
• The volume control bar will disappear about 10 seconds after the VOLUME button is released.
• The VOLUME buttons don't function while the menu selection bar or the menu is being displayed.
• When a high-level audio signal, such as a DVD audio signal, is supplied to the AUDIO IN terminals, the output
from the speaker may be distorted.
• When the audio cable is connected to the AUDIO OUT terminal, the speaker output is muted.
• The volume of the audio from the AUDIO OUT terminal is also changed by pressing the VOLUME buttons.
• The VOLUME value varies within the range between 0 and 21, and the same value is applied during projection and
power standby.
You can change the volume during power standby by pressing VOLUME + or - button after the following setting is
done.
(See page 26 for menu setting.)
1. Display the INSTALLATION menu.
2. Select VOLUME ADJUSTMENT by pressing the  or  button.
3. Select PROJECTION AND STANDBY by pressing the  or  button.
4. Set STANDBY MODE to STANDARD. (See page 28.)
EN-20