Table of Contents
Advertisement
Specifi cations
The specifi cations and outside appearance of the projector are subject to change without prior notice.
Type
Model
Display technology
Projection lens
Light-source
Image size
Maximum resolution
Computer/component video input
Video input
Audio input
HDMI input
Monitor output
Audio output
Speaker
Control terminal/others
Operating temperatures
Projection angles
Rated voltage
Power consumption
Dimensions
Weight
Others
DLP™ projector
NW31U-EST
0.65-inch single chip Digital Micromirror Device (DMD)
Pixels: 1280 x 800 = 1024000 pixels
F 2.7 f= 5.4 mm
LED and laser
70" min. to 180" max.
Computer signal
Maximum resolution: 1920 x 1200 dots (compressed)
Panel resolution: 1280 x 800 dots
Video signal
NTSC/PAL/SECAM/4.43NTSC/PAL-M/PAL-N/PAL-60
Component signal
480i, 480p, 576i, 576p, 720p, 1080i, 1080p
Panel resolution: 1280 x 800 dots
[Signal type]
Analog RGB
[Signal type]
Video input
S-video input
[Signal type]
RGB/Component
Video/S-video
[Signal type]
HDMI
[Signal type]
Analog RGB
10 W Mono Round type x 1
RS-232C (D-SUB 9-pin), LAN (RJ-45), USB Type-A
+41°F (+5°C) to +95°F (+35°C)
Standard altitude mode: All projection angle of front and rear direction
High altitude mode: Floor installation/ceiling installation
AC 100 - 240 V, 50/60 Hz
3.4 A, 320 W
During standby:
375 mm (W) x 136 mm (H) x 310 mm (D)
5.4 kg
S-video input
Luminance signal: Vp-p=1.0 V 75 Ω (negative sync)
Chrominance signals: Vp-p=0.286 V 75 Ω (burst signal)
Video input
Vp-p=1.0 V 75 Ω (negative sync)
Component video
YC
input
Analog input
RGB: Vp-p=0.7 V 75 Ω (negative sync)
YC
HD/CS: TTL-level (negative or positive polarity)
VD: TTL-level (negative or positive polarity)
Digital input (HDMI)
HDMI interface (TMDS single link) (Only PCM audio is supported.)
Audio input
350 mVrms, 10 kΩ or more
[Terminal type]
Mini D-SUB 15-pin
[Terminal type]
RCA
S
[Terminal type]
Stereo mini jack (ø3.5)
RCA (L, R)
[Terminal type]
HDMI 19-pin
[Terminal type]
Mini D-SUB 15-pin
[Terminal type]
Stereo mini jack (ø3.5)
AC 100 - 120 V: 0.2 W (when STANDBY MODE is LOW)
AC 220 - 240 V: 0.3 W (when STANDBY MODE is LOW)
C
: Vp-p=1.0 V 75 Ω (Y) (negative sync)
B
R
Vp-p=0.7 V 75 Ω (C
C
: Vp-p=1.0 V (Y) (negative sync) Vp-p=0.7 V (C
B
R
EN-71
(not including protrusion)
, C
)
B
R
B
[Line]
2
[Line]
1
1
[Line]
2
1
[Line]
1
[Line]
1
[Line]
1
, C
)
R
Advertisement
Table of Contents
