Market Forge Industries MT-25EO Installation & Operation Manual page 9

Modular base electric tilting kettles

Modular Base Electric Tilting Kettles

Install Pan Support

1. With both hands, hold pan support in front of upright supports. Cutouts on each side must be facing upward and

jointed links must be allowed to fall free.

2. Place stud – located on left hand upright support – into hole in left hand side of pan support. After engaging left hand

side, push right hand side in until spring loaded pin on right hand side of pan support engages hole in pan support.

3. Rotate pan support up to near vertical position. Shifts both hands to lowermost links and simultaneously engage their

slotted ends to studs at base of each upright support.

4. Allow pan support to drop back to horizontal position where it will automatically lock. Pan support should now be firmly

in place.

5. To tilt kettle, remove crank handle from its stored position inside of cabinet door.

6. Insert crank handle into tilt kettle mechanism.

7. Pour out finished product from kettle by turning crank handle clockwise to tilt kettle. Liquids may be drawn off through

draw-off valve to a stock pot. Lower kettle by turning crank handle counterclockwise.

Crank handle turning may be stopped at any point without kettle setting back.

8. Add water to kettle for cleaning purposes.

9. Wash kettle thoroughly, see Daily Cleaning Instructions.

Figure 3

INSTALLATION & OPERATION MANUAL 14-00330 REV 0 (07/21)

When removing pan support, reverse the above installation sequence.

Full 110° tilt is obtained in approximately 42 turns of the crank.

NOTICE

PERATION

PAGE

OF 16

Table of Contents

Mt-40eo