Usb Programming Port; Configuration Software; Earliest Version Software Requirements For The Pc - Crestron MT-1000C Programming Manual

3.8 Inch RF Remote

Configuration Software

2 • 3.8 Inch RF Remote: MT-1000C
NOTE: When using firmware 2.22, the hard buttons do not work when the low
battery warning is displayed.

USB Programming Port

Located on the rear side, this port connects to a computer with a USB cable
(included with the MT-1000C) for loading operation programming.
MT-1000C Rear View
Have a question or comment about Crestron software?
Answers to frequently asked questions (FAQs) can be viewed in the Online Help
section of the Crestron website. To post a question or view questions you have
submitted to Crestron's True Blue Support, log in at http://support.crestron.com.
First-time users will need to establish a user account.
The MT-1000C provides a wireless RF user interface in a Cresnet
control system, and also works with X-Series using a CNRFGWA-418 gateway.
NOTE: Crestron recommends using gateway CNRFGWA-418 or control
system MC2W units that shipped after February 15, 2005. Earlier units are not
compatible with the MT-1000C. If you have an earlier unit, it may be returned
for an upgrade. Contact Crestron customer support for more information.
You can create a program that allows you to set up the MT-1000C to operate a
Crestron control system using the Crestron programming tool SIMPL Windows.
Earliest Version Software Requirements for the
PC
NOTE: Crestron recommends that you use the latest software to take advantage
of the most recently released features. The latest software is available from the
Crestron website.
NOTE: Crestron software and any files on the website are for Authorized
Crestron dealers and Crestron Authorized Independent Programmers (CAIP)
only. New users are required to register to obtain access to certain areas of the
site (including the FTP site).
Crestron MT-1000C
®
Programming Guide - DOC. 6330A
2-Series