Project Upload And Firmware Upgrade - Crestron MT-1000C Programming Manual

Crestron MT-1000C

Project Upload and Firmware Upgrade

Programming Guide – DOC. 6330A
Before loading a compiled VT Pro-e project or upgrading the device firmware,
the USB cable supplied with the MT-1000C must be connected to the USB
interface port on the rear of the MT-1000C and the USB port of the PC as shown
in the following diagram.
NOTE: You cannot operate the MT-1000C while a file is loading.
NOTE: All of the communication parameters are automatically set when
uploading to the MT-1000C.
NOTE: An error message will appear on the PC if you have installed the USB
connector up side down.
Typical Connection Diagram when Uploading and Upgrading
NOTE: The Crestron Toolbox (replacement for Crestron Viewport) is a broad-
based software package that accomplishes multiple system tasks, primarily using
an RS-232 or TCP/IP connection between a PC and one or more Crestron
control systems. You can use the Crestron Toolbox to:
● Observe system processes
● Upload operating systems and firmware
● Upload programs and touchpanel projects
● Set or change device Network IDs
● Change serial numbers
● Run scripts to automate tasks
● Perform system diagnostics, and much more
The Crestron Toolbox allows you to perform these functions using simple
graphical views and click and drag methods.
3.8 Inch RF Remote
3.8 Inch RF Remote: MT-1000C • 23