Table of Contents
Advertisement
Five independent bands of fully parametric EQ can be used to adjust
the tonal balance of the speaker to the user's preference, or to tune the
speaker to a particular room's acoustic characteristics.
Q-factor equates to the bandwidth of the filter. A high Q means that the filter
will have a very sharp peak, only affecting a narrow range of frequencies. A
low Q means that the filter will have a broad peak, affecting a wide range of
frequencies. A Q value of 1.41 is equivalent to a bandwidth of one octave.
Logo Brightness
Range: Min (10%) to 100%
This parameter adjusts the brightness of the PMC logo on the front of the
speaker.
At the minimum (10%) setting the logo will only glow when activated by the
driver protection system or to indicate user interaction with the SoundAlign
web interface.
Store Presets A, B, C
Each speaker can store three complete user configurations internally,
identified as Presets A, B and C.
When the LCD shows "Store Preset X" press the VALUE encoder to begin the
preset storage process, then press again within three seconds to confirm. All
settings (except XBD Mode) will be stored in the speaker's memory.
Load Presets A, B, C
Any one of the three stored presets can be recalled from the speaker's
memory.
When the LCD shows "Load Preset X" press the VALUE encoder to begin the
preset loading process, then press again within three seconds to confirm.
All settings (except XBD Mode) will be loaded from the speaker's memory.
Load Factory Default Settings
This option reverts the speaker to its initial factory configuration, removing
all EQs and other user settings. Stored presets will not be affected by this
process.
When the LCD shows "Load Defaults" press the VALUE encoder to begin
the process, then press again within three seconds to confirm. All settings
(except XBD Mode) will be returned to their factory default values.
Clear XBD Links
This option removes any XBD links that have been created either through
the SoundAlign web interface or through an automatic standalone XBD
pairing and sets XBD Mode to OFF. See the section on XBD configurations
for more details.
Advertisement
Table of Contents
