Canon FAX-L170 Starter Manual page 24

Power Supply Requirements
220 to 240 V, 50/60 Hz
IMPORTANT
Precautions when connecting the power cord
• Do not connect this machine to an uninterruptible power source.
• Use an AC power outlet exclusively for the machine. Do not use the other sockets
of the AC power outlet.
• Do not plug the power plug into the auxiliary outlet on a computer.
Do not use the same AC power outlet for both the machine and any of the
following equipment.
- Copy machine
- Air conditioner
- Shredder
- Equipment that consumes a large amount of electricity
- Equipment that generates electrical noise
• When unplugging the power cord, keep interval of 5 seconds or more before
plugging it again.
Miscellaneous precautions
• The maximum power consumption of the machine is 1,200 W or less.
• Electrical noise or a dramatic drop in supplied voltage may cause the machine or
computer to operate incorrectly or lose data.Installation Requirements
• A location with sufficient space
• A location with good ventilation
• A location with a flat, even surface
• A location able to fully support the weight of the machine
IMPORTANT
Do not install the machine in the following locations, as this may result in
damage to the machine.
• A location subject to dramatic changes in temperature or humidity
• A location subject to condensation
• A poorly ventilated location
(If you use the machine for a long time or to perform a large amount of printing
in a poorly ventilated room, the ozone or other odors generated by the machine
may create an uncomfortable working environment. In addition, chemical
particles are dispersed during printing; therefore, it is important to provide
adequate ventilation.)
• A location near equipment that generates magnetic or electromagnetic waves
• A laboratory or location where chemical reactions occur
• A location exposed to salt air, corrosive gases, or toxic gases
• A location, such as on a carpet or mat, that may warp from the weight of the
machine or where the machine is liable to sink.
Maintenance and Inspections
IMPORTANT
• Follow the instructions in the caution label attached to this machine.
• Avoid shaking or applying a shock to this machine.
• To prevent a paper jam, do not turn the power ON/OFF, open/close the operation
panel or rear cover, and load/unload paper in the middle of printing operation.
• Be sure to remove the toner cartridge from the machine when transporting the
machine to a distance.
• To avoid exposing the toner cartridge to light, place it in the protective bag
included with this machine or wrap it in a thick cloth.
• Clean this machine regularly. If this machine becomes dusty, it may operate
improperly.
• Use a modular cable of 3 m or shorter in length.
• Depending on your locale or your telephone connection, you may be unable to
perform data communication. In this case, contact your local authorized Canon
dealer or the Canon help line.
• The repairing parts and toner cartridges for the machine will be available
for at least seven (7) years after production of this machine model has been
discontinued.
Contacting Service Center
When you have a problem with your machine and you cannot solve it, even if you
refer to the manuals or online help, please contact your local authorized Canon
dealer from whom you purchased the equipment (if under warranty), or with whom
you have a servicing contact.
24
Legal Notices
Model Names
FAX-L170 (F162002)
FAX-L150 (F162004 )
EMC requirements of EC Directive
This equipment conforms with the essential EMC requirements of EC Directive. We
declare that this product conforms with the EMC requirements of EC Directive at
nominal mains input 230 V, 50 Hz although the rated input of the product is 220 to
240 V, 50/60 Hz. Use of shielded cable is necessary to comply with the technical EMC
requirements of EC Directive.
International ENERGY STAR Program
As an ENERGY STAR
this product meets the ENERGY STAR Program for energy
efficiency.
The International ENERGY STAR Office Equipment Program is an
international program that promotes energy saving through the
use of computers and other office equipment.
The program backs the development and dissemination
of products with functions that effectively reduce energy
consumption. It is an open system in which business proprietors
can participate voluntarily.
The targeted products are office equipment, such as computers,
displays, printers, facsimiles, and copiers. The standards and
logos are uniform among participating nations.
WEEE Directive
-European Union (and EEA) only-
This symbol attached on the product is according to the WEEE Directive
(2002/96/EC).
-India only-
This product is not to be disposed of with your household waste,
according to the e-waste (Management and Handling) Rules, 2011. This
product should be handed over to a designated collection point, e.g., to
an authorized collection site for recycling waste electrical and electronic
equipment (EEE). Improper handling of this type of waste could have
a possible negative impact on the environment and human health
due to potentially hazardous substances that are generally associated
with EEE. At the same time, your cooperation in the correct disposal of
this product will contribute to the effective usage of natural resources. For more
information regarding return and recycling of WEEE products, please visit http://
www.canon.co.in/environment.
Also, this product complies with the "India E-waste Rule 2011" and prohibits use of
lead, mercury, hexavalent chromium, polybrominated biphenyls or polybrominated
diphenyl ethers in concentrations exceeding 0.1 % by weight and 0.01 % by weight
for Cadmium, except for the exemptions set in Schedule II of the Rule.
Laser Safety Information
Laser radiation could be hazardous to the human body. For this reason, laser
radiation emitted inside this equipment is hermetically sealed within the protective
housing and external cover. No radiation can leak from the machine in the normal
operation of the product by the user.
This machine is classified as a Class 1 Laser Product under IEC 60825-1: 2007,
EN60825-1: 2007.
Partner, Canon Inc. has determined that
®