HoMedics Walgreens WGNBPA-755BT Manual page 12

Using Single Measurement Mode:
1.
located on the back of the unit, is in the OFF position.
2. Press the USER-SELECT button
Pulse
/min.
START
USER
MEM
1/2 STOP
After the user number is selected, press the START/STOP
button to confirm the chosen user.
SYS.
3. With the cuff wrapped around your arm, press the START/
mmHg
STOP button. Do not inflate the cuff unless it is wrapped
around your arm. All digits will light up to check the display
about 3 seconds.
DIA.
mmHg
Pulse
/min.
START
USER
MEM
1/2 STOP
Note:
after the checking procedure is complete.
SYS.
mmHg
DIA.
mmHg
ON
22
4. After all symbols disappear, the display
Measure" and will automatically inflate
cuff will start deflating as measurement
continues.
Note:
5. When the measurement is completed, the
cuff will deflate entirely. Systolic pressure,
diastolic pressure and pulse will be shown
measurement is then automatically
stored into memory.
Note:
60 seconds after last operation. You may also
press the START/STOP button to return to standby mode.
STOP (recommended) MEM USER- SELECT or DATE/
TIME SET ( ) buttons.
after a button is pressed.
"Ready to
The
SYS.
mmHg
DIA.
mmHg
START/
23