Gavita CT 1930e Quick Start Manual page 6

2. With our Controller
a. Remove the cable gland assembly.
Remove the dummy plug from the Input terminal (save for future use).
b.
c. Refer to Section 7.4 to assemble the water tight cable gland assembly over the Input cable to the first fixture of your
continuous chain.
d. For instructions on how to connect to subsequent fixtures, refer to Section 7.4 on Daisy Chaining.
3. With a Third Party Controller
a. Follow the same steps as 7.3.2.
b. When connecting to the controller, please refer to Section 7.5.
7.3 Daisy Chain
•
Remove the protective cable gland from the RJ45 in port (fig. 13).
•
Remove the Dummy Plug (fig. 14).
•
Undo the rear nut of the protective cable gland and pull out the rubber seal (fig. 14 & 15).
•
Slide cable through the Securing Nut and the gland covering (fig. 16).
•
Plug the cable into the RJ45 "IN" port (fig. 17).
•
Place the rubber seal on the wire between the securing nut and the gland covering and press it into the protective gland (fig. 17).
•
Tighten cable gland onto the RJ45 connector "IN" port (fig. 18).
•
Tighten the securing nut onto the gland cover to create a seal (fig. 19).
•
Repeat these steps for all ports in the daisy chain.
13.
16.
19.
HGC906121 Gavita
Master Controller EL2 - Gen 2
14.
17.
6
15.
18.