IKOS MONO User Manual page 121

Time periods (ProG)
Navigate using the P4 button inside the submenu Chrono to the parameters "ProG" and press
the P3 button to edit the value and access the time periods. With the P2 and P4 buttons, select
the time period of the selected mode (Gior-SEtt-FiSE) and press the P3 button.
Each time period has one hour to turn on and one hour to turn off, for each mode it is possible
to choose up to 3 time periods for automatic operation. In order to the chosen mode become
active it's necessary to insert at least one time period.
In the time period 1, to select the turn on hour [1, Mo], hold the P1 button for 3 seconds until
00.00 appears in the top display. Press the P3 button to edit the hour that will be blinking. Press
P2 and P4 buttons to select the desired hours and minutes and press P3 to validate and set the
minutes. Again, use the P2 and P4 buttons to select and the P3 button to validate.
After the turn on time been chosen in the time period 1, next step is to define the turn off time
for this time period. Press P2 button to show the turn off hour [1' Mo] and repeat the previous
process to select the desired time.
Time is selected in periods of 15 minutes (ex.:20:00, 20:15, 20:30, 20:45).
NOTE: Only after 23 PM it's possible to select minutes from 45 to 59 in order to turn on the
stove before midnight.
Recipe function "PELL''
The properties of the pellets in the market can be different from brand to brand, namely size
(length) and calorific value. In this sense it may be useful to adjust the pellet feed (by the user)
to compensate for these differences.
The adjust can be made in a range of -7 to +7, with 0 being the factory setting, decreasing to
negative numbers will reduce the pellets debt and increase the value will grow the pellets debt.
Decreasing too much the pellet debt might influence the lighting process (more slow),
however increasing too much may cause a violent lighting of the stove.
With the stove working, decreasing too much the debt of pellets may cause inconsistent
behaviour in the minimal power mode (the stove might turn off), and if is too high, this
might perturb the work in higher power modes (richer combustion, bigger flame and
more residues).
Pellet loading function
The pellet load option is only available if the stove is completely off, this option is for activate
the pellet feeder screw in cases like the first lighting (see page 118, lighting for the first time) or
EN // 121
USER'S MANUAL
EN