Table of Contents
Advertisement
REMOVING THE POWER CORD AND
CABINET-MOUNTED TERMINAL BLOCK
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1.
Disconnect the power to the drying cabi-
net.
2.
Remove the component panel (see page
4-2 for the procedure).
3.
To remove the power cord:
a) Remove the nut from the ground wire
stud, and remove the green power cord
wire from the stud.
b) Loosen the two power cord strain re-
lief clamp screws.
c) Loosen the 3 wire screws in the cabi-
net-mounted terminal block, pull the
black, white, and green/yellow power
cord wires out of the terminals, and re-
move the cord from the cabinet. NOTE:
Make sure that you reconnect the cor-
rect wires to the terminal block screws,
as shown in the photo.
4.
To remove the cabinet-mounted termi-
nal block:
a) Perform step 3c.
b) Remove the two cabinet-mounted ter-
minal block screws, and remove the
block from its mounting bracket.
Strain Relief Clamp Screws
Ground
Wire Nut
WARNING
Electrical Shock Hazard
Connect ground wire to ground screw.
Failure to do so can result in death or
electrical shock.
4-9
Power Cord
Terminal Block Screws
Wire Terminal Screws
Wht / Yel / Blk Wires
Advertisement
Table of Contents
