Removing The Timer - Whirlpool DryAire LMA1053L Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1. Disconnect the power to the drying cabi-
net.
2. Remove the component panel (see page
4-2 for the procedure).
3. Remove the two mounting screws and
lockwasher from the shield and remove
the shield from the component panel.
Shield
Screw
4. Remove the knob from the timer shaft.
Timer Knob

REMOVING THE TIMER

Screw &
Lockwasher
4-4
5. Remove the two screws and lockwashers
from the timer.
Timer Screws/
Lockwashers
6. Disconnect the wires from the thermostat
terminals. NOTE: Be sure to reconnect
the wires to the proper thermostat termi-
nals.
To
To Fan Motor
Terminal
Block
To Timer
(Ground)
To Heater
To Fan Motor
To Terminal Block
Thermostat