Winter Operation; Trouble-Shooting - Dometic 8 Series Operating Instructions Manual

5.12 Winter operation

5.13 Trouble-shooting

5.13.1 Status messages on the display
MES Appliances
D
MES Display :
LED is blinking*
LED is blinking*
LED is blinking*
All temperature setting
LEDs are blinking*
LED + temperature
level LEDs are blinking*
LED + temperature
level LEDs are blinking*
* In case of failure, the "failure" indicator LED illuminates in red. When AES models are concerned,
an acoustic signal is initiated.
Fig. 39
Fig. 40
G
Fig. 41
AES Display :
„230V" is blinking*
„12V" is blinking*
„GAS" is blinking*
Alle Temperaturstufen-
LED blinken*
„HE1" is blinking*
„HE2" is blinking*
17
THE SIGN OF COMFORT
THE SIGN OF COMFORT
In winter, check that the ventilation grills and the
exhaust duct system have not been blocked by
snow, leaves, etc..
When the outside temperature falls below +8°C,
the winter cover should be fitted. This protects
the unit from excessively cold air which could
has adverse effects on the performance of the
unit.
You should also attach the winter cover if the
vehicle is taken out of service for a longer period
of time or while it is being cleaned from the out-
side.
AES Appliances
D
Failure :
230V mode: voltage not available or too low
12V mode: voltage not available or too low
GAS/Auto mode: flamme not ignited
Temperature sensor defective, refrigerator works on
mid temperature setting
230V - Heating element defective
12V - Heating element defective
G
Fig. 42