Advertisement
GENERAL USAGE AND SAFETY GUIDELINES
Disconnect the power cord from the wall outlet before cleaning and maintenance.
To clean the appliance outside, use a damp cloth, a soft brush or a fine sponge, and
MAINTENANCE
then wipe it dry.Do not use coarse abrasive cleaning agents or sharp metal scrapers
Disconnect the power cord from the wall outlet before cleaning and maintenance. To clean the
for cleaning of the appliance as this could result in surface scoring.
applianes outside, use a damp cloth, a soft brush or a ne sponge, and then wipe it dry. Do not
Never leave aggressive or acidic substances (lemon juice, vinegar) on enamelled or
use coarse abrasive cleaning agents or sharp metal scrapers for cleaning of the appliance as this
stainless parts of the appliance.
could result in the surface scoring. Never leave aggressive or acidic substances ( lemon juice,
vinegar ) on enamelled or stainless parts of the appliance.
Cleaning and replacement of filters
Cleaning and replacement of lters
Metal grease filters
Metal Grease Filters
When the appliance is in common use, the metal grease filters should be checked
When the appliance is in common use, the metal grease lters should be checked or cleaned
or cleaned every month. In case of more frequent frying or deep frying, shorten this
every month. In case of more frequent frying deep frying, shorten this interval.
interval.
Do not use the appliance without the metal grease lters properly installed!
Do not use the appliance without the metal grease filters properly installed!
1.Remove the metal filters as shown in Fig. 1.
1. Remove the metal lters as show in Fig. 1
2.Let the metal filters soak in warm water with addition of a detergent or put them
2. Let the metal lters soak in warm water with the addition of a detergent or put them into a
into a washer with a cleaning agent and set temperature below 60 °C. In case of
washer with a cleaning agent and set temperature below 60°C. In case of soaking in warm water,
soaking in warm water, clean the metal filters with a fine brush, rinse them with
clean the metal lters with a ne brush, rinse them with clean water and let them dry.
clean water and let them dry.
3. Attach the dried lters back.
3.Attach the dried filters back.
Charcoal lter ( to be purchased )
This lter is only used for the recirculation mode.
The lter contains an active carbon absorbing the smell being discharged. The active carbon
will be saturated after some time, hence the absorption capacity will be shortened. This lter
cannot be washed or cleaned in any other way.
When the appliance is in common use, the charcoal lter should be replaced every 2-3 months.
In case of more frequent frying or deep frying, shorten this interval.
1. Remove the metal lters as shown in Fig. 2
2. Install the charcoal lter on the side of the engine.
Fig.1
6
Advertisement
