Faber Pro Magnum Installation Instructions And Use & Care Manual

Faber wall mount canopy rangehood
Hide thumbs Also See for Pro Magnum:

Advertisement

READ THESE INSTRUCTIONS BEFORE YOU START INSTALLING THIS RANGEHOOD
WARNING: - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE: Never leave surface units unattended at high settings.
Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium setting. Always turn hood ON
when cooking at high heat or when cooking flaming foods. Clean ventilating fans frequently. Grease should not be allowed to
accumulate on fan or filter. Use proper pan size. Always use cookware appropriate for the size of the surface element.
WARNING: - TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
FOLLOWING: SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO
PREVENT BURNS. If the flames do not go out immediately EVACUATE AND CALL THE FIRE DEPARTMENT. NEVER PICK UP A
FLAMING PAN - You may be burned. DO NOT USE WATER, including wet dishcloths or towels - a violent steam explosion will result.
Use an extinguisher ONLY if: 1. You know you have a Class ABC extinguisher, and you already know how to operate it. 2. The fire
is small and contained in the area where it started. 3. The fire department is being called. 4. You can fight the fire with your back to
an exit.
ALL WALL AND FLOOR OPENINGS WHERE THE RANGEHOOD IS INSTALLED MUST BE SEALED.
This rangehood requires at least 30" of clearance between the bottom of the rangehood and the cooking surface or countertop. The maximum
depth of overhead cabinets is 13". Overhead cabinets on both sides of this unit must be a minimum of 18" above the cooking surface or countertop.
Consult the cooktop or range installation instructions given by the manufacturer before making any cutouts. MOBILE HOME INSTALLATION
The installation of this rangehood must conform to the Manufactured Home Construction and Safety Standards, Title 24 CFR, Part 3280 (formerly
Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280). Four wire power supply must be used and the appliance
wiring must be revised. See Electrical Requirements.
AVERTISSEMENT - POUR MINIMISER LE RISQUE D'UN FEU DE GRAISSE SUR LA TABLE DE CUISSON : Ne jamais laisser
un élément de la table de cuisson fonctionner sans sur-veillance à la puissance de chauffage maximale; un renversement/
déborde-ment de matière graisseuse pourrait provoquer une inflammation et le génération de fumée. Utiliser toujours une
puissance de chauffage moyenne ou basse pour le chauffage d'huile. Veiller à toujours faire fonctionner le ventilateur de la
hotte lors d'une cuis-son avec une puissance de chauffage élevée ou lors de la cuisson d'un mets à flamber. Nettoyer
fréquemment les ventila-teurs d'extraction. Veiller à ne pas laisser de la graisse s'accumuler sur les surfaces du ventilateur
ou des fil-tres. Utiliser toujours un ustensile de taille appropriée. Utiliser toujours un usten-sile de taille adapté à la taille de
l'élé-ment chauffant..
AVERTISSEMENT: - POUR PRÉVENIR LES BLESSURES EN CAS DE FEU SUIVRE LES RECOMMANDATIONS SUIVANTES:
ÉTOUFFEZ LE FEU avec un couvercle métallique et fermez le brûleur. Si le feu ne s'éteint pas tout de suite, QUITTEZ LES
LIEUX ET APPELEZ LES POMPIERS. NE TOUCHEZ JAMAIS UNE CASSEROLE EN FLAMMES. N'UTILISEZ JAMAIS DE
L'EAU ou un torchon mouillé pour éteindre le feu - ce qui pourrait causer une explosion de vapeur. N'utilisez un extincteur
que si: 1. Vous avez un modèle ABC et vous connaissez bien son mode d'emploi. 2. Le feu est petit et peu répandu. 3.
Les pompiers sont déjà prévenus. 4. Vous avez une sortie derrière vous.
TOUTE OUVERTURE DANS LE MUR OU LE PLANCHER À PROXIMITÉ DE LA HOTTE DOIT ÊTRE SCELLÉ
Gardez 30 po. de hauteur entre le bas de la hotte et la surface de cuisson. Les armoires au-dessus ne dépasseront pas 13 po. de
profondeur. Les armoires au-dessus de chaque côté devront être au moins à 18 po. au-dessus de la surface de cuisson. Consultez
la fiche technique avant de découper les armoires. L'installation de cette hotte doit être conforme aux Réglements de Manufactured
Home Construction and Safety Standards, titre 24 CFR, Section 3280 (anciennement Federal Standard for Mobile Home
Construction and Safety Standards, titre 24 CFR, Section 3280 (anciennement Federal Standard for Mobile Home Construction and
Safety, titre 24, HUD, Section 280). Le branchement électrique se fait avec une raccordement à 4 fils. Consultez la fiche technique
électrique.
LISEZ BIEN CETTE FICHE AVANT D'INSTALLER LA HOTTE
PRO MAGNUM
Wall Mount Canopy Rangehood

• Installation Instructions

• Use and Care Information

READ AND SAVE THESE INSTRUCTIONS
The Installer must leave these instructions with the homeowner.
The homeowner must keep these instructions for future reference
and for local electrical inspectors' use.
Version 12/02 - Page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Pro Magnum and is the answer not in the manual?

Questions and answers

Summary of Contents for Faber Pro Magnum

  • Page 1: Installation Instructions

    PRO MAGNUM Wall Mount Canopy Rangehood • Installation Instructions • Use and Care Information READ AND SAVE THESE INSTRUCTIONS The Installer must leave these instructions with the homeowner. The homeowner must keep these instructions for future reference and for local electrical inspectors' use.
  • Page 2 This appliance should be connected directly to the fused VENTING REQUIREMENTS disconnect (or circuit breaker) through flexible, armored or nonmetallic sheathed copper cable. Allow some slack in Determine which venting method is best for your applica- the cable so the appliance can be moved if servicing is ever tion.
  • Page 3 RÈGLEMENTS D'ÉVACUATION AVERTISSEMENT - POUR RÉDUIRE LE RISQUE D'INCENDIE OU DE CHOC ELECTRIQUE, ne pas utiliser Confirmer la sortie d'évacuation - soit par le mur, soit par le ce ventilateur en conjonction avec un dispositif de toit. réglage de vitesse à semi-conducteurs. Utilisez une longueur de tuyauterie minimale avec les AVERTISSEMENT –...
  • Page 4: Calculate The Ductrun Length

    CALCULATE THE DUCTRUN LENGTH TOOLS NEEDED FOR INSTALLATION • Saber Saw or Jig Saw The ductrun should not exceed 35 equivalent • Drill feet if ducted with the required minimum of 3 45˚ Elbow 3.0 feet • 1 1/4" Wood Drill Bit 1/4"...
  • Page 5: Prepare The Wall

    Determine and make all necessary cuts in the wall for the If a backsplash is to be used with this rangehood, it must be ductwork. The Pro Magnum vents either through the top or the installed before the rangehood. Installation instructions for rear of the rangehood.
  • Page 6: Install The Rangehood

    INSTALL THE RANGEHOOD Remove the unit from the carton and place on a flat surface for assembly. Cover the surface to prevent accidental damage. Remove all parts including the mounting hardware before discarding the carton. Remove the grease filters USING TWO HANDS (one to hold the filter so that it doesn't fall on cooktop and one to turn the knob) by pulling the knob out and turning to the left.
  • Page 7: Warranty And Service

    Rangehood Control Panel or the local Faber distributor. If you cannot identify a local The control panel is located on the right-hand side under the Faber distributor, contact us at (508) 358-5353 for the canopy.

Table of Contents