Transmitter Test Setup; Transmit/Receive Test Window - E.F. Johnson Company 5100 Series Assembly And Test Procedures

Tuning and Performance Tests
1 In the Menu Bar, select Tools > Tx/Rx Tests.
2 In the Transmit/Receive Tests window (Figure 4.1), select Test Type: Receive.
3 In the Transmit/Receive Tests window, select Receive Test: Short, or Receive Test:
Long. After this is selected, the radio audio mutes.
Figure 4.1
4 Set the Communications Analyzer output level for one of the following levels at the
radio's antenna jack:
Series
5100
5100 ES 700/800 -119 dBm (0.25
The Bit Error Rate (BER) should be 5% or less.
5 Increase the analyzer output level to 1000 µV (–47 dBm). The BER should be less than
0.01%. This is the BER Rate Floor.
4.3.3
Complete the procedures of 4.1, "Digital Test Preparation."
4-4 PC Tune Test Procedures for 5100 Series Portable Radios

Transmit/Receive Test Window

Band Test Setting
700/800 -119 dBm (0.25 µV)
VHF -117 dBm (0.32 µV)
µV)
UHF R1 -117 dBm (0.32
µV)
UHF R2 -117 dBm (0.32
µV)

Transmitter Test Setup

August 2008