Service Test Mode - Trane Odyssey Series Installation Manual

Service Test Mode

Service Test Mode provides the ability to energize the various components of the system, either to support general system startup tasks or to
support troubleshooting. Below are the steps to initiate Service Test Mode. For detailed information on how each Service Test State
is interpreted based on the equipment configuration, refer to the Symbio 700 Odyssey Controls Application Guide (ACC-APG001*-EN).
1. On the home screen, select the tools icon
at the bottom of the screen to navigate to the
Settings screen.
Figure 36. Home screen
4. When a test is active, the status turns
green and displays the name of the active test
mode.
Figure 39. Active service test mode screen
SS-SVN016A-EN
S S y y m m b b i i o o S S e e r r v v i i c c e e a a n n d d I I n n s s t t a a l l l l a a t t i i o o n n M M o o b b i i l l e e A A p p p p l l i i c c a a t t i i o o n n
2. Select Service Test Mode.
Figure 37. Tools screen
5. To exist Service Test Mode, click the stop
icon next to the active test mode. Active test
modes time out after the Service Test
Timeout timer (60 minutes default) expires or
power is cycled to the controller.
Figure 40. Active service test mode screen
3. Select any of the green play icons to
initiate that test mode.
Figure 38. Service test mode screen
39