Wi-Fi Setup; Network And Password - Kodak VERITE Craft 6 Extended User Manual

Wi-Fi Setup

Select Wi-Fi Setup type and follow the Menu display instructions.
Note(s)
By factory default, the DHCP (Dynamic Configuration
●
Control Protocol) function is set to On, and it automatically
assigns a local IP address to your printer.
If you would like to set the IP address manually, refer to
●
below.
You can setup from the Menu Control Panel, then select the
–
[IP Address]. IP Address...Navigate to [Home > Setup > Wi-
Fi Setup > IP Address], then press
» Refer to "IP Address" on page 54.
When performing Network connection, make sure the unit
●
is not placed too far away from the Access Point/Router and
the Access Point/Router is powered On and its settings are
correct.
If you need additional help on Network problems, visit our
website at www.kodakverite.com/support

Network and Password

1
If you would like to connect to a Router manually, press
to select [Network and Password], then press
.
Wi-Fi Setup
Network and Password
Wi-Fi Protected Setup
Skip
2
SSID names of Routers are listed on the Menu display. Select
the SSID that you would like to connect to, then press
.
If the SSID that you would like to connect to is not displayed
●
in the list, select [Other], then press
name, then select the security type of the Router.
Network and Password
Router1
Router2
Router3
Router4
Back
English
Wi-Fi Setup
Network and Password
Wi-Fi Protected Setup
Skip
OK
.
OK
. Enter the SSID
OK Select
3
[Enter Password] will appear on the Menu display, then
enter Password. Press
press . After entering the Password, press
to select [Done], then press
If you would like to use capital letters, numbers or symbols,
●
press
When you enter a wrong letter, then you can erase it by
●
pressing .
a
k l m n o p q r s t
u v w x y z
4
Confirm the SSID name and Password displayed on the
Menu display, then press
connecting to the Router.
SSID: Router1
Password:
Xaxswordxssdaa123456
5
[Connected to ...] message will appear on the Menu display
when the Connection is successful. Press
Connection setting is completed.
» Refer to "Network and Password" on page 53.
16
to select a letter, then
.
to select [a/A/1/+], then press
Network and Password
Enter Password
b c d e f g h i j
a/A/1/+
< > Done
. The unit will start
Network and Password
Back OK Continue
Network and Password
Connected to
Router1
Press to print report.
Press OK to continue.
Print OK Continue
Continued on next page.
.
, then the