AutoAqua Smart ATO micro Faq

AutoAqua Smart ATO micro Faq

Advertisement

Smart ATO micro FAQ
How to set up the siphon break properly?
1.
Are drops of water from the siphon break a normal phenomenon
2.
when the pump's on?
What will happen if the siphon break is not set up properly?
3.
Why is the head height not high enough?
4.
Is there an alert when the reservoir is empty?
5.
Can Smart ATO micro still work if the glass is not transparent?
6.
How does the redundancy work for the Smart ATO micro?
7.
Why is the water level always a little higher than the sensor? Is the
8.
sensor broken?
Why does the red LED flash with audible alert? I have checked the
9.
water reservoir and the bubble but there is no problem.
How to use other pumps with Smart ATO micro?
10.
How to extend the cable length of the pump/solenoid valve/power
11.
supply?
Can I use the solenoid valve with Smart ATO micro? How to install it?
12.
How to purchase accessories?
13.
Copyright ©2018 AUTOAQUA Technologies Co., Ltd. All rights reserved
Smart ATO micro FAQ AUG. 2018 v.2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Smart ATO micro and is the answer not in the manual?

Questions and answers

Summary of Contents for AutoAqua Smart ATO micro

  • Page 1 How to use other pumps with Smart ATO micro? How to extend the cable length of the pump/solenoid valve/power supply? Can I use the solenoid valve with Smart ATO micro? How to install it? How to purchase accessories? Smart ATO micro FAQ AUG. 2018 v.2...
  • Page 2 Consequently, the tank/sump will be overfilled and more water will come out Smart ATO micro FAQ AUG. 2018 v.2 Copyright ©2018 AUTOAQUA Technologies Co., Ltd. All rights reserved...
  • Page 3 Can Smart ATO micro still work if the glass is not transparent? Yes. Since the water level senor of Smart ATO micro is inside of the tank/sump, the surface will not be a factor that influences the sensing of water level.
  • Page 4 If you want to move the sensor or change the water level, you have to repeat the above steps. How to use other pumps with Smart ATO micro? You can use a pump which meets your requirement with our Smart AC Socket: http://autoaqua.com.tw/en/accessories/SAC-10.html.
  • Page 5 16.7 ft (500 cm): http://autoaqua.com.tw/en/accessories/DC-215.html Can I use the solenoid valve with Smart ATO micro? How to install it? Yes. The solenoid valve can be in ATO pump’s place. It is recommended using with filtered water instead of tap water, or it will be clogged. Please refer to the installation diagram below.
  • Page 6 How to purchase accessories? Please contact our local distributors: http://autoaqua.com.tw/en/distributors.html. Smart ATO micro FAQ AUG. 2018 v.2 Copyright ©2018 AUTOAQUA Technologies Co., Ltd. All rights reserved...

Table of Contents