Square The Table To The Spindle; Connect To A Dust Collector - Delta 31-484 Instruction Manual

SQUARE THE TABLE TO THE SPINDLE

To ensure proper operation and consistent results, the
spindle must be square to the table surface. To check
the alignment
1. Make sure the spindle tilt indicator is at 90°.
If necessary, see instructions for "Adjusting
the Spindle Tilt" on page 13 and reposition the
spindle to 90°.
2. Use a square with one side flush against the spindle
and the other side resting on the table surface to
check the alignment of the table relative to the
spindle.
If the table is out of square, you must adjust the 90°
positive stop. Refer to Figure 9 and do the following:
1. Unlock the lock knob on the motor cover (Figure 1
on page #) and open the cover.
2. Locate the 90° positive stop collar (A) on the long
threaded rod (B) that runs front to back on the left
side of the machine.
NOTE: There are two stop collars located on the
threaded rod. The collar furthest to the rear of the

CONNECT TO A DUST COLLECTOR

The spindle sander creates a large amount of dust while in use. It is strongly recommended that you connect the
spindle sander to a dust collector. Your DELTA
dust port which is located at the bottom in the rear of the machine. This must be connected to dust collector hoses
to ensure safe operation.
Do not attempt to operate this tool without first connecting it to an adequate dust collection system.
Always turn on the dust collector before starting the sander and always stop the sander before
turning off the dust collector.
ASSEMBLY
machine is the 90° positive stop collar.
3. Loosen the 2 set screws on the 90° positive stop
collar, using a 3mm hex wrench.
4. Rotate the 90° positive stop collar, re-tighten the
set screws and re-measure the table alignment,
repeating steps 2 and 3 if necessary until table and
spindle are in square.
5. Adjust the spindle tilt indicator to read 90°
by unscrewing the four Phillips head screws
securing the tilt indicator window to the cabinet
and removing the window. Loosen the tilt arrow
retaining screw, reposition the arrow, re-tightening
the retaining screw.
® Heavy Duty Oscillating Floor Spindle Sander is equipped with a 4"
11
FIGURE 9