Communication Type; Temperature Units; Set Language - JP Selecta Digitronic-TFT 2005163 Instruction Manual

MANUAL DE INSTRUCCIONES
PORT
RS232
TIME
Do not save
MODE
Start
SEND
0
Fig 7.2. Comunication
CORRECT T
CORRECT. T
(0) 176ºC
ALM OVERT
ALARM SOBRE T
0.0 ºC
ALM UNDER T
ALARM BAJO T
0.0 ºC
Fig 7.2. Temperature alarms
J
.P. SELECTA s.a.
CODIGO 80305 REV 0 Feb/2015

7.2.3 Communication type

The equipment can store readings from time to time and send them to a
computer or store them in a USB memory pen.
«PORT»
• RS232:
• USB:
«INTERVAL»
«MODE»
• Start:
• Set point:
• PC:
«SEND»
7.2.4 Set the temperature and the temperature
alarms
It is recommended to verify calibration of temperature with some regularity
(for example, annually), by using for instance a thermometer or a tempera-
ture pattern.
If it is necessary to correct the reading, as a result of calibration, one must
enter a correction.
To do this, press on this icon:
A box indicating the current correction value appears.
Adjust with keys
perature pattern.
Applied correction will appear in brackets.
7.2.4.1 Temperature alarms
By pressing successively on the temperature correction box, one may enter
an over-temperature and low-temperature limit. Both alarms activate a
message on screen.

7.2.5 Temperature units

Press on the Temperature units icon. Press successively to change between
Celsius or Farenheit degrees.

7.2.6 Set language

Press on the language icon. Press successively on the box to select among
Spanish, French or English.
Adjust by pressing on the increase and decrease icons.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
(Sujetas a modifi caciones sin previo aviso)
Set the readings storing mode:
Send the temperature readings to a computer by a serial
cable (DB9 type).
Store the readings in a USB memory pen drive.
Select the register time interval and the data sending.
Select the data to be stored:
Save all temperature readings.
Save temperature readings, since the set point tempera-
ture has been reached.
Send data, it is not stored.
Number of stored data, pending from sending.
until you get the indicated value on the tem-
Tel 34 937 700 877 Fax 34 937 702 362
Pag.: 17